On the suitability of photocuring-assisted DIW for manufacturing complex prosthesis from commercial dental composites
Open Access
- 30 September 2024
- journal article
- research article
- Published by Springer Nature in Journal of Materials Science: Materials in Medicine
- Vol. 35 (1) , 1-11
Abstract
A 3-D printing method to produce dental prostheses of complex shapes from a commercial, photocurable resin-ceramic slurry is developed and optimized. The microstructure, mechanical properties and wear behavior of the resulting material are evaluated and compared with a conventional/control sample and other ceramic-polymer dental composites. Commercial resin-ceramic dental slurries can be successfully extruded and appropriately photocured in a low cost 3-D printing system to produce cost-efficient complex dental parts that could be used in indirect restorations. The printing process does not appreciably introduce defects in the material and the 3-D printed composites exhibit mechanical properties (hardness, elastic modulus) and wear resistance comparable to the control material and analogous, conventional dental composites. The main wear mechanisms under sliding contact against a hard antagonist are plastic deformation at the asperity level and ceramic particle pull-out due to filler/matrix interfacial weakness. Graphical Abstract 3-D printing commercial resin-filler slurries creates cost-efficient tooth prostheses with properties akin to conventional dental compositesKeywords
Funding Information
- Ministerio de Ciencia e Innovación (PID2021-123218OB-I00)
This publication has 28 references indexed in Scilit:
- Applicability of near-field electrospinning for the development of TCP-based thin fibres and scaffold 3D printingBoletín de la Sociedad Española de Cerámica y Vidrio, 2022
- Effects of the test method on wear measurements in dental enamel/ceramic tribosystemsCeramics International, 2022
- Novel bioinspired composites fabricated by robocasting for dental applicationsCeramics International, 2021
- The tooth: An analogue for biomimetic materials design and processingDental Materials, 2020
- Innovative in situ photocuring-assisted 3D plotting technique for complex-shaped ceramic architectures with high shape retentionCeramics International, 2019
- Filler characteristics of modern dental resin composites and their influence on physico-mechanical propertiesDental Materials, 2016
- An in vitro study of the wear behaviour of dental compositesBiosurface and Biotribology, 2016
- Mechanics of microwear traces in tooth enamelActa Biomaterialia, 2015
- Wear behavior of dental Y-TZP ceramic against natural enamel after different finishing proceduresDental Materials, 2012
- Resin composite—State of the artDental Materials, 2011