A dummy for the objective ride comfort evaluation of ground vehicles
- 29 January 2009
- journal article
- research article
- Published by Taylor & Francis in Vehicle System Dynamics
- Vol. 47 (3) , 343-362
Abstract
A new device for an objective evaluation of ground vehicle ride comfort is presented. In this study, the ride comfort (frequency range 0–30 Hz) has been referred to the acceleration acting along the vertical axis (subject spine) and to the longitudinal acceleration (acting at the subject shoulders). Based on the experimental measurements of such accelerations on different human subjects seated on a car seat, a proper mechanical/mathematical model of the seat+subject has been derived. The derivation of the model has been performed by minimising the error between the measured and the computed accelerations. A prototype of the derived mechanical model has been actually built. Particular attention has been devoted to the construction of the springs, of the moving members and of the magnetic damper. All of the device parameters (mass, stiffness, damping) can be easily tuned. Finally, an experimental validation of the device has been performed. The device, while seated with the same posture of the corresponding human subject is able to reproduce (with reasonable accuracy) both the acceleration along the subject spine and the acceleration at the subject shoulders.Keywords
This publication has 6 references indexed in Scilit:
- Resonance behaviour of the seated human body and effects of postureJournal of Biomechanics, 1997
- Dynamik der Kraftfahrzeuge1990
- The apparent mass of the seated human body: Vertical vibrationJournal of Biomechanics, 1989
- On frequency-dependent damping coefficients in lumped-parameter models of human beingsJournal of Biomechanics, 1976
- A model for the response of seated humans to sinusoidal displacements of the seatJournal of Biomechanics, 1974
- The Mechanical Impedance of the Human Body in Sitting and Standing Position at Low FrequenciesHuman Factors: The Journal of the Human Factors and Ergonomics Society, 1962