Investigations on Process Parameters of Wire Arc Additive Manufacturing (WAAM): A Review
- 14 January 2021
- book chapter
- Published by Springer Nature
- p. 845-853
Abstract
No abstract availableKeywords
This publication has 20 references indexed in Scilit:
- Dissimilar metal deposition with a stainless steel and nickel-based alloy using wire and arc-based additive manufacturingPrecision Engineering, 2016
- The effect of inter-layer cold working and post-deposition heat treatment on porosity in additively manufactured aluminum alloysJournal of Materials Processing Technology, 2016
- A comparative study of additive manufacturing techniques: Residual stress and microstructural analysis of CLAD and WAAM printed Ti–6Al–4V componentsMaterials & Design, 2016
- Effect of arc mode in cold metal transfer process on porosity of additively manufactured Al-6.3%Cu alloyThe International Journal of Advanced Manufacturing Technology, 2014
- Plasma arc welding: Process, sensing, control and modelingJournal of Manufacturing Processes, 2014
- Microstructure and residual stress improvement in wire and arc additively manufactured parts through high-pressure rollingJournal of Materials Processing Technology, 2013
- Direct Digital Manufacturing2010
- Design and Development of the Blackbird: Challenges and Lessons Learned2009
- Investigation of the overlapping parameters of MPAW‐based rapid prototypingRapid Prototyping Journal, 2006
- A new rapid tooling technique and its special binder studyRapid Prototyping Journal, 1999