Aircraft Propeller Design through Constrained Aero-Structural Particle Swarm Optimization
Open Access
Abstract
An aero-structural algorithm to reduce the energy consumption of a propeller-driven aircraft is developed through a propeller design method coupled with a Particle Swarm Optimization (PSO). A wide range of propeller parameters is considered in the optimization, including the geometry of the airfoil at each propeller section. The propeller performance prediction tool employs a convergence improved Blade Element Momentum Theory fed by airfoil aerodynamic characteristics obtained from XFOIL and a validated OpenFOAM. A stall angle correction is estimated from experimental NACA 4-digits data and employed where convergence issues emerge. The aerodynamic data are corrected to account for compressibility, three-dimensional, viscous, and Reynolds number effects. The coefficients for the rotational corrections are proposed from experimental data fitting. A structural model based on Euler-Bernoulli beam theory is employed and validated against Finite Element Analysis, while the impact of centrifugal forces is discussed. A case of study is carried out where the chord and pitch distributions are compared to minimal losses distribution from vortex theory. Wind tunnel tests were performed with printed propellers to conclude the feasibility of the entire routine and the differences between XFOIL and CFD optimal propellers. Finally, the optimal CFD propeller is compared against a commercial propeller with the same diameter, pitch, and operational conditions, showing higher thrust and efficiency.Keywords
This publication has 32 references indexed in Scilit:
- Grey Wolf OptimizerAdvances in Engineering Software, 2014
- Design of Flexible Propellers with Optimized Load-Distribution CharacteristicsJournal of Aircraft, 2014
- A simple solution method for the blade element momentum equations with guaranteed convergenceWind Energy, 2013
- Turbulence modeling of deep dynamic stall at relatively low Reynolds numberJournal of Fluids and Structures, 2012
- Development and application of an improved blade element momentum method model on horizontal axis wind turbinesInternational Journal of Energy and Environmental Engineering, 2012
- Optimization of Propeller Based Propulsion SystemJournal of Aircraft, 2009
- State of the art in wind turbine aerodynamics and aeroelasticityProgress in Aerospace Sciences, 2006
- Investigating Three-Dimensional and Rotational Effects on Wind Turbine Blades by Means of a Quasi-3D Navier-Stokes SolverJournal of Fluids Engineering, 2000
- Compressibility Effects in AerodynamicsJournal of the Aeronautical Sciences, 1941
- Two-Dimensional Subsonic Flow of Compressible FluidsJournal of the Aeronautical Sciences, 1939