The Effects of Temperature and Moisture Exposure on the Properties of Wood-Fiber Thermoplastic Composites
Authors:
- 1 September 1997
- journal article
- research article
- Published by SAGE Publications in Journal of Thermoplastic Composite Materials
- Vol. 10 (5) , 476-487
Abstract
Wood-fiber thermoplastic composites were prepared with polypropylene (PP) and high-density polyethylene (HDPE) matrix resins employing high shear thermokinetic compounding for fiber dispersion. Wood fibers obtained from recycled newspapers were mixed with the matrix polymers at a level of 30% by weight. In one experiment, sets of six samples were immersed in boiling water for up to 48 hours and subsequently tested for mechanical properties and water absorption. In another experiment, samples were exposed to -40'C, -20'C, 00C, 230C, 40'C and 60'C for two hours and then tested at the same temperatures for tensile and flexural properties. Results showed that immersion in boiling water resulted in water absorption of between 3 and 5%, a decrease in tensile and flexural properties, and an increase in impact strength. When the composites were exposed to various temperatures, both strength and modulus decreased significantly with increasing temperatures above ambient (23°C) level for both PPand HDPE-based composites. The opposite trend was evidenced below freezing.Keywords
This publication has 8 references indexed in Scilit:
- The nature of adhesion in composites of modified cellulose fibers and polypropyleneJournal of Applied Polymer Science, 1991
- Wood Flour/Polypropylene Composites: Influence of Maleated Polypropylene and Process and Composition Variables on Mechanical PropertiesInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1991
- Effect of Recycling on the Mechanical Properties of Wood Fiber-Polystyrene Composites. II. Sawdust as a Reinforcing FillerPolymer-Plastics Technology and Engineering, 1990
- The effect of aging conditions on the mechanical properties of wood fiber-polystyrene composites: I. Chemithermomechanical pulp as a reinforcing fillerComposites Science and Technology, 1989
- Use of grafted aspen fibers in thermoplastic composites: IV. Effect of extreme conditions on mechanical properties of polyethylene compositesPolymer Composites, 1986
- The Efficiency of Cellulosic Fillers in Common Thermoplastics. Part II. Filling with Processing Aids and Coupling AgentsInternational Journal of Polymeric Materials and Polymeric Biomaterials, 1985
- Wood fibers as reinforcing fillers for polyolefinsPolymer Engineering & Science, 1984
- The Chemistry of Wood Strength1984