The Effects of Strain Rates on Mechanical Properties and Failure Behavior of Long Glass Fiber Reinforced Thermoplastic Composites
Open Access
Abstract
Long glass fiber reinforced thermoplastic composites have been increasingly used in automotive parts due to their excellent mechanical properties and recyclability. However, the effects of strain rates on the mechanical properties and failure mechanisms of long glass fiber reinforced polypropylene composites (LGFRPPs) have not been studied systematically. In this study, the effects of strain rates (from 0.001 s−1 to 400 s−1) on the mechanical properties and failure mechanism of LGFRPPs were investigated. The results showed that ultimate strength and fracture strain of the LGFRPPs increased obviously, whereas the stiffness remained essentially unchanged with the strain rates from low to high. The micro-failure modes mainly consisted of fibers pulled out, fiber breakage, interfacial debonding, matrix cracking, and ductile to brittle (ductile pulling of fibrils/micro-fibrils) fracture behavior of the matrix. As the strain rates increased, the interfacial bonding properties of LGFRPPs increased, resulting in a gradual increase of fiber breakage at the fracture surface of the specimen and the gradual decrease of pull-out. In this process, more failure energy was absorbed, thus, the ultimate strength and fracture strain of LGFRPPs were improved.Keywords
Funding Information
- National Natural Science Foundation of China (51621004;51975202)
- Natural Science Foundation of Hunan Province (2019JJ30005;2017GK2090)
This publication has 46 references indexed in Scilit:
- Long fiber thermoplastics are a key technology in expanding existing markets for compositesReinforced Plastics, 2019
- Strain rate dependent mechanical behavior of glass fiber reinforced polypropylene composites and its effect on the performance of automotive bumper beam structureComposites Part B: Engineering, 2019
- Investigation of the Viscoelastic Behavior Variation of Glass Mat Thermoplastics (GMT) in Compression MoldingPolymers, 2019
- Designing and Preparation of Fiber-Reinforced Composites with Enhanced Interface AdhesionPolymers, 2018
- Tensile Creep Behavior of Quasi-Unidirectional E-Glass Fabric Reinforced Polypropylene CompositePolymers, 2018
- Influence of the Processing Parameters on the Fiber-Matrix-Interphase in Short Glass Fiber-Reinforced ThermoplasticsPolymers, 2017
- Design and manufacturing of long fiber thermoplastic composite helmet insertComposite Structures, 2017
- Shear induced fiber orientation, fiber breakage and matrix molecular orientation in long glass fiber reinforced polypropylene compositesMaterials Science and Engineering: A, 2011
- Process simulation, design and manufacturing of a long fiber thermoplastic composite for mass transit applicationComposites Part A: Applied Science and Manufacturing, 2008
- LFTs for automotive applicationsReinforced Plastics, 2005