Influence of the Reaction Injection Moulding Process on the Thermomechanical Behaviour of Fast Curing Polyurethane
Open Access
- 3 May 2022
- journal article
- research article
- Published by MDPI AG in Journal of Manufacturing and Materials Processing
- Vol. 6 (3) , 53
Abstract
In this contribution, the influence of the reaction injection moulding process on the thermomechanical material behaviour of aliphatic hexamethylene diisocyanate (HDI) based fast curing polyurethane is demonstrated. Uniaxial tensile tests, temperature-frequency dependent dynamic mechanical thermal analysis (DMTA) and Differential Scanning Calorimetry (DSC) are used to show the differences in properties for ten different sets of process parameters. The mould and resin components temperature, the mass flow during the filling process and the residence time during the reaction process of the polyurethane are varied in several stages. Further experiments to determine the molar mass of the molecular chain between two crosslinking points of the polyurethane are used to explain the process influences on the thermomechanical properties. Thus, a direct correlation between manufacturing and material properties is shown. In addition, the mutual effect of the different parameters and their overall influence on the material behaviour is presented.Keywords
Funding Information
- Bundesministerium für Wirtschaft und Energie (ZF4101115BL8)
This publication has 47 references indexed in Scilit:
- Influence and prediction of processing parameters on the properties of microcellular injection molded thermoplastic polyurethane based on an orthogonal array testJournal of Cellular Plastics, 2013
- Preparation and properties of novel ultraviolet-cured waterborne polyurethanesHigh Performance Polymers, 2013
- Temperature and Mold Size Effects on Physical and Mechanical Properties of a Polyurethane FoamJournal of Cellular Plastics, 2005
- Cross-linking kinetics and swelling behaviour of aliphatic polyurethanePolymer, 2000
- The effect of crosslinking on properties of polyurethane elastomersJournal of Applied Polymer Science, 1991
- Gel content determination in cross-linked polyethyleneBiomaterials, 1989
- Phase structure of polyetherpolyol‐4,4′‐diphenylmethane diisocyanate‐based reaction injection molded (RIM) polyurethanesPolymer Engineering & Science, 1986
- Eine einfache Theorie des mechanischen und dielektrischen Relaxationsverhaltens während der Bildung eines Polymernetzwerkes aus reaktiven OligomerenActa Polymerica, 1980
- Relation of structure to properties in polyurethanesJournal of Applied Polymer Science, 1960
- Effects of Molecular Structure on Physical Properties of Butyl RubberRubber Chemistry and Technology, 1946