Abstract
High-strength alloy steels such as 34CrNiMo6 are important for use within high value, high-load engineering applications. Its hardness and strength are important metrics that influence material performance and can be increased and optimised by induction hardening (IH) heating. This paper investigates the influence of IH post quenching and tempering (Q&T) (860 °C quench, 400 °C temper, air cooled) on 34CrNiMo6 bulk material properties. Contrary to expectations, as listed within ISO 18265, a 130 MPa reduction to ultimate tensile strength, Rm was identified with IH compared to the Q&T alloy condition despite an increase in hardness. Missing from the literature was an explanation for this behaviour, which was addressed here by microstructural analysis, and showed that IH produced a predominantly martensitic structure with coarser grains than its Q&T counterpart due to additional austenitization. These findings indicated that the combined strengthening mechanisms present within the Q&T microstructure outperformed the strength gains through martensitic transformation from IH, especially when grain coarsening was introduced. This work aids the design of complex engineering pieces where IH is assumed to yield strength increases along with hardness.