Effect of Sintering Time on the Density, Porosity Content and Microstructure of Copper – 1 wt. % Silicon Carbide Composites
Authors:
- 1 December 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Advanced Materials Research
- Vol. 1064, 32-37
Abstract
In this paper, several copper matrixes reinforced with 1 wt. % silicon carbide (SiC) were fabricated using powder metallurgy (PM). The effect of sintering time (30 min, 60 min, 90 min, and 180 min) on composite density and porosity, and grain size were investigated. The results showed that longer sintering time gives higher sintered density, and smaller porosity content. This is due to the diffusion enhancement, which leads to reduce pore size, and close porosities. Also, for a given compaction pressure, the grains tend to be coarser for longer sintering time, due to the materials tendency to reduce grain boundary surface energy. In addition, samples compacted at high pressure have finer grain than corresponding grains compacted at low pressure but sintered for the same time.Keywords
This publication has 8 references indexed in Scilit:
- Influence of sintering parameters on the properties of powder metallurgy Ti–3Al–2.5V alloyMaterials Characterization, 2013
- Effect of sintering time on the microstructure and mechanical properties of (Ti,Ta)(C,N)-based cermetsInternational Journal of Refractory Metals and Hard Materials, 2013
- Effect of powder metallurgy conditions on the properties of porous bronzePowder Technology, 2013
- Effect of Sintering Parameters on Microstructure and Properties of Mechanically Alloyed Copper-Tungsten Carbide CompositeInternational Journal of Materials, Mechanics and Manufacturing, 2013
- Effects of processing parameters of tungsten–copper compositesInternational Journal of Refractory Metals and Hard Materials, 2012
- Effect of sintering temperature and time on densification, microstructure and properties of the PZT/ZnO nanowhisker piezoelectric compositesJournal of Alloys and Compounds, 2011
- The effect of particle size, sintering temperature and sintering time on the properties of Al–Al2O3 composites, made by powder metallurgyJournal of Materials Processing Technology, 2009
- Phase distribution and associated mechanical property distribution in silicon carbide particle-reinforced aluminium fabricated by liquid metal infiltrationJournal of Materials Science, 1994