Development of a High-Specific-Speed Centrifugal Compressor
Author:
- 1 July 1997
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 119 (3) , 501-505
Abstract
This paper describes the development of a subscale single-stage centrifugal compressor with a dimensionless specific speed (Ns) of 1.8, originally designed for full-size application as a high volume flow, low pressure ratio, gas booster compressor. The specific stage is noteworthy in that it provides a benchmark representing the performance potential of very high-specific-speed compressors, of which limited information is found in the open literature. Stage and component test performance characteristics are presented together with traverse results at the impeller exit. Traverse test results were compared with recent CFD computational predictions for an exploratory analytical calibration of a very high-specific-speed impeller geometry. The tested subscale (0.583) compressor essentially satisfied design performance expectations with an overall stage efficiency of 74 percent including, excessive exit casing losses. It was estimated that stage efficiency could be increased to 81 percent with exit casing losses halved.Keywords
This publication has 5 references indexed in Scilit:
- Experiments With a Low-Specific-Speed Partial Emission Centrifugal CompressorJournal of Turbomachinery, 1990
- A Study of Performance Improvement for High Specific Speed Centrifugal Compressors by Using Diffusers With Half Guide VanesJournal of Fluids Engineering, 1987
- The Performance of Centrifugal Compressor Channel Diffusers1982
- A Diffusion Factor Correlation for Centrifugal Impeller StallingJournal of Engineering for Power, 1978
- Performance Investigations of Large Capacity Centrifugal Compressors1978