Analysis and modeling of intermediate-scale reservoir heterogeneity based on a fluvial point-bar outcrop analog, Williams Fork Formation, Piceance Basin, Colorado
- 1 July 2007
- journal article
- Published by American Association of Petroleum Geologists AAPG/Datapages in AAPG Bulletin
- Vol. 91 (7) , 1025-1051
Abstract
This study presents results of outcrop characterization and modeling of lithologic heterogeneity within a well-exposed point bar of the Williams Fork Formation in Coal Canyon, Piceance Basin, Colorado. This deposit represents an intermediate-scale depositional element that developed from a single meandering channel within a low net-to-gross ratio fluvial system. Williams Fork outcrops are analogs to petroleum reservoirs in the Piceance Basin and elsewhere. Analysis and modeling of the point bar involved outcrop measurements and ground-based high-resolution light detection and ranging data; thus, the stratigraphic frameworks accurately represent the channel-fill architecture. Two- and three-dimensional (2-D and 3-D) outcrop models and streamline simulations compare scenarios based on different lithologies, shale drapes, observed grain-size trends, petrophysical properties, and modeling methods. For 2-D models, continuous and discontinuous shale drapes on lateral-accretion surfaces result in a 79% increase and 24% decrease in breakthrough time (BTT), respectively, compared to models without shale drapes. The discontinuous shale drapes in the 2-D and 3-D models cause a 30% and 107% decrease, respectively, in sweep efficiency because they focus fluid flow downward to the base of the point bar. For similar reasons, 2-D models based on grain size exhibit 67–267% shorter BTT and 44–57% lower sweep efficiency compared to other model scenarios. Unlike the 2-D models, the continuous shale drapes in the 3-D models cause the fluid front to spread out and contact more of the reservoir, resulting in 42–53% longer BTT and 41–52% higher sweep efficiency compared to the other models. These results provide additional insight into the significance of intermediate-scale heterogeneity of fluvial reservoirs.Keywords
This publication has 42 references indexed in Scilit:
- Hydraulic Effects of Shales in Fluvial-Deltaic Deposits: Ground-Penetrating Radar, Outcrop Observations, Geostatistics, and Three-Dimensional Flow Modeling for the Ferron Sandstone, UtahMathematical Geology, 2002
- Geologic Modelling of External and Internal Reservoir Architecture of Fluvial Depositional Systems2002
- A semianalytic approach to tracer flow modeling in heterogeneous permeable mediaAdvances in Water Resources, 1995
- A Revised Alluvial Stratigraphy Model1993
- Inclined heterolithic stratification—Terminology, description, interpretation and significanceSedimentary Geology, 1987
- Stochastic Simulation1987
- RESERVOIR HETEROGENEITIES AND THEIR INFLUENCE ON ULTIMATE RECOVERY1986
- Studies in fluviatile sedimentation: an exploratory quantitative model for the architecture of avulsion-controlled alluvial suitesSedimentary Geology, 1978
- Fluviatile fining-upwards cycles and the magnitude of palaeochannelsGeological Magazine, 1973
- Miocene point‐bar deposits in the Ebro Basin, Northern Spain*Sedimentology, 1973