Numerical analysis of centrifugal compressor operating in near-surge conditions
Authors:
Open Access
- 23 October 2018
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1101 (1) , 012017
Abstract
In order to reproduce the near-surge operation of centrifugal compressor a series of numerical simulations in ANSYS CFX have been conducted. Different settings of boundary conditions have been investigated in purpose of providing a combination allowing to model surge without non-physical flow constraints. This, in turn, would be a step towards modelling of antisurge system. As the conclusions, it was observed that there is no possibility of simulating nearsurge working regime without mass flow rate definition as a boundary condition. However, it is achievable to determine a throttle characteristic, which can be used as a function defining the outlet pressure and indirectly the mass flow rate. In case of transient simulations, it would allow to analyse both steady and unsteady regimes of the flow in a centrifugal compressor.Keywords
This publication has 12 references indexed in Scilit:
- Robust control of a two-state Greitzer compressor model by state-feedback linearization2016
- Large Eddy Simulation for a Deep Surge Cycle in a High-Speed Centrifugal Compressor With Vaned DiffuserJournal of Turbomachinery, 2015
- Unsteady CFD Simulation for High Speed Centrifugal Compressor Operating Near Surge2014
- Investigation of the Surge Phenomena in a Centrifugal Compressor Using Large Eddy Simulation2013
- Large Eddy Simulation of the Unsteady Flow in a Radial Compressor Operating Near SurgeJournal of Turbomachinery, 2012
- Unsteady Flow in a Turbocharger Centrifugal Compressor: Three-Dimensional Computational Fluid Dynamics Simulation and Numerical and Experimental Analysis of Impeller Blade VibrationJournal of Turbomachinery, 2005
- Active compressor surge control using a one-sided controlled bleed/recycle valve2002
- Computational Analysis of Centrifugal Compressor Surge Control Using Air InjectionJournal of Aircraft, 2001
- Development and application of a CFD solver to the simulation of centrifugal compressors1998
- Surge and Rotating Stall in Axial Flow Compressors—Part I: Theoretical Compression System ModelJournal of Engineering for Power, 1976