The Limitations of Using “Ra” to Describe Surface Roughness
- 26 April 2016
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 138 (10) , 101003
Abstract
Current criteria used to determine whether rough surfaces affect skin friction typically rely on a single amplitude parameter to characterize the roughness. The most commonly used criteria relate the centerline averaged roughness, Ra, to an equivalent sandgrain roughness size, ks. This paper shows that such criteria are oversimplified and that Ra/ks is dependent on the roughness topography, namely, the roughness slope defined as the roughness amplitude normalized by the distance between roughness peaks, Ra/λ. To demonstrate the relationship, wake traverses were undertaken downstream of an aerofoil with various polished surfaces. The admissible roughness Reynolds number (ρ1u1Ra/μ1) at which the drag rose above the smooth blade case was determined. The results were used to demonstrate a 400% variation in Ra/ks over the roughness topographies tested. The relationship found held for all cases tested, except those where the roughness first initiated premature transition at the leading edge. In these cases, where the roughness was more typical of eroded aerofoils, the drag was found to rise earlier.Keywords
This publication has 5 references indexed in Scilit:
- High fidelity replication of surface texture and geometric form of a high aspect ratio aerodynamic test componentSurface Topography: Metrology and Properties, 2016
- Admissible Roughness in Gas Turbines2015
- A Review of Surface Roughness Effects in Gas TurbinesJournal of Turbomachinery, 2010
- Unsteady Transition Phenomena at a Compressor Blade Leading EdgeJournal of Turbomachinery, 2008
- 1999 Turbomachinery Committee Best Paper Award: Development of Advanced Compressor Airfoils for Heavy-Duty Gas Turbines— Part II: Experimental and Theoretical AnalysisJournal of Turbomachinery, 1999