Residual Strains in an Al 2 O 3 ‐Ni Joint Bonded with a Composite Interlayer: Experimental Measurements and FEM Analyses
- 1 June 1998
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 81 (6) , 1541-1549
Abstract
A cylindrical Al 2 O 3 ‐Ni joint bonded with a 4.0 mm thick composite interlayer of 40 vol% Al 2 O 3 ‐60 vol% Ni was fabricated by powder processing, and the residual strains in the specimen were studied experimentally using neutron diffraction, X‐ray diffraction, and optical fluorescence spectroscopy. Experimental measurements were compared with finite element modeling results obtained using a variety of different constitutive assumptions. The predicted residual strain distribution within the Al 2 O 3 along the center of the specimen was in reasonable agreement with neutron diffraction measurements, although the magnitude of the error in the experimental measurements did not allow a distinction to be made between the various modeling assumptions examined. In contrast, the predicted peak strains within the Al 2 O 3 along the specimen surface were significantly higher than those measured by X‐ray diffraction or optical fluorescence spectroscopy, suggesting that strain relief occurred near the free edge during cooling. The mechanism of strain relief is believed to involve damage accumulation within the composite interlayer that was not accounted for in the constitutive models used.Keywords
This publication has 21 references indexed in Scilit:
- Diffraction Peak Displacement in Residual Stress Samples Due to Partial Burial of the Sampling VolumeJournal of Applied Crystallography, 1997
- Mapping of the residual stress distribution in a brazed zirconia-iron jointMaterials Science and Engineering: A, 1996
- X-ray stress measurement and FEM analysis of residual stress distribution near interface in bonded ceramic/metal compoundsScripta Materialia, 1996
- FEM study of the effects of interlayers and creep in reducing residual stresses and strains in ceramic-metal jointsComposites Engineering, 1995
- Thermal Stresses in Ceramic‐Metal Joints with an InterlayerJournal of the American Ceramic Society, 1995
- Residual Stresses in Ceramic–Interlayer–Metal JointsJournal of the American Ceramic Society, 1993
- Residual Stress State of Brazed Ceramic/Metal Compounds, Determined by Analytical Methods and X‐ray Residual Stress MeasurementsJournal of the American Ceramic Society, 1990
- Metal/ceramic joining.ISIJ International, 1990
- Effects of X-ray beam collimation on the measurement of residual stress distribution in a Si3N4/steel joint.ISIJ International, 1990
- Generalised Least-squares Determination of Triaxial Stress States by X-ray Diffraction and the Associated ErrorsAustralian Journal of Physics, 1988