Monitoring Damage Using Acoustic Emission Source Location and Computational Geometry in Reinforced Concrete Beams
Open Access
- 26 January 2018
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 8 (2) , 189
Abstract
Non-destructive testing in reinforced concrete (RC) for damage detection is still limited to date. In monitoring the damage in RC, 18 beam specimens with varying water cement ratios and reinforcements were casted and tested using a four-point bending test. Repeated step loads were designed and at each step load acoustic emission (AE) signals were recorded and processed to obtain the acoustic emission source location (AESL). Computational geometry using a convex hull algorithm was used to determine the maximum volume formed by the AESL inside the concrete beam in relation to the load applied. The convex hull volume (CHV) showed good relation to the damage encountered until 60% of the ultimate load at the midspan was reached, where compression in the concrete occurred. The changes in CHV from 20 to 40% and 20 to 60% load were five and 13 times from CHV of 20% load for all beams, respectively. This indicated that the analysis in three dimensions using CHV was sensitive to damage. In addition, a high water-cement ratio exhibited higher CHV formation compared to a lower water-cement ratio due to its ductility where the movement of AESL becomes wider.Keywords
This publication has 40 references indexed in Scilit:
- Application of Convex Hull Algorithm for Defect Detection in Selected Biological MaterialsSolid State Phenomena, 2013
- Fatigue crack propagation monitoring by Acoustic Emission signal analysisEngineering Fracture Mechanics, 2012
- Fracture behavior of concrete–concrete interface using acoustic emission techniqueEngineering Fracture Mechanics, 2010
- Mesoscopic modeling of Acoustic Emission through an energetic approachInternational Journal of Solids and Structures, 2008
- Development of a Damage Detection Scheme Applicable to Sandwich CompositesJournal of Sandwich Structures & Materials, 2007
- Relative damage evaluation of concrete in a road bridge by AE rate-process analysisMaterials and Structures, 2006
- Damage Monitoring of an Historical Masonry Building by the Acoustic Emission TechniqueMaterials and Structures, 2006
- P-Wave Arrival Determination and AE Characterization of ConcreteJournal of Engineering Mechanics, 2000
- The history and development of acoustic emission in concrete engineeringMagazine of Concrete Research, 1996
- The quickhull algorithm for convex hullsACM Transactions on Mathematical Software, 1996