Ultrafine Particles Deposition Inside Passenger Vehicles
Authors:
Open Access
- 13 March 2009
- journal article
- research article
- Published by Taylor & Francis in Aerosol Science and Technology
- Vol. 43 (6) , 544-553
Abstract
Although commuting time typically accounts for only 6% of the day for Americans, it has become a significant source of exposure to ultrafine particles (d p < 0.1 μ m) from vehicular emissions. Particle deposition onto surfaces, as an important particle loss mechanism, has been studied extensively in the indoor environments. However since air velocities, surface area to volume ratios and other contributing factors differ greatly between indoor and in-cabin environments, conclusions from indoor studies may not be directly applied to in-cabin microenvironments. In this study, ultrafine particle deposition rates were characterized under a range of air velocities and surface areas conditions inside different types of passenger vehicles. A diesel generator was used as a particle source and a Scanning Mobility Particle Sizer (SMPS) was used to measure ultrafine particle size distribution inside the test vehicles. As in-cabin air velocities increased from natural convection (< 0.02 m s–1 ) to 0.65 m s–1 , ultrafine particle deposition rates increased with the greatest increases occurred for smaller particles. Other influencing factors, such as the number of passengers inside the vehicle, were also considered and investigated. It was found that ultrafine particle deposition rates are proportional to the surface areas inside vehicles consistent with previous indoor studies. Compared with available ultrafine particle deposition rates reported in the indoor environments, the in-cabin ultrafine particle deposition rates found in this study are about 3 to 20 times greater. This is likely due to higher air velocities and larger surface area to volume ratios in the in-cabin microenvironment.Keywords
This publication has 46 references indexed in Scilit:
- Deposition of Fine and Ultrafine Particles on Indoor Surface MaterialsIndoor and Built Environment, 2008
- Measurements and predictors of on-road ultrafine particle concentrations and associated pollutants in Los AngelesAtmospheric Environment, 2008
- The Pulmonary Toxicology of Ultrafine ParticlesJournal of Aerosol Medicine, 2002
- Indoor particle pollution: effect of wall textures on particle depositionBuilding and Environment, 2001
- Epidemiologic Evidence of Cardiovascular Effects of Particulate Air PollutionEnvironmental Health Perspectives, 2001
- Relative Contribution of Outdoor and Indoor Particle Sources to Indoor ConcentrationsEnvironmental Science & Technology, 2000
- Size specific indoor aerosol deposition measurements and derived I/O concentrations ratiosAtmospheric Environment, 1997
- Wall Deposition of Radon Progeny and Particles in a Spherical ChamberAerosol Science and Technology, 1997
- Stable tracer aerosol deposition measurements in a test chamberJournal of Aerosol Science, 1995
- Turbulent deposition and gravitational sedimentation of an aerosol in a vessel of arbitrary shapeJournal of Aerosol Science, 1981