Experimental and Finite Element Analysis of GFRP Composite Laminates with Combined Bolted and Bonded Joints
Authors:
Open Access
- 1 April 2017
- journal article
- Published by Indian Society for Education and Environment in Indian Journal of Science and Technology
- Vol. 10 (14) , 1-7
Abstract
The scope this research work is to develop and study the finite element analysis of GFRP composite laminates with combined bolted and bonded joint. Polymer matrix composite materials are widely used due to the reason of high strength to weight ratio. Design techniques for fastened joints have received valuable attention due to the different nature of the stress field in the proximity of the joint, the different of failure modes that can occur. A foremost goal of bolted joint research is to limit the effect of several bolting parameters on the bearing strength of the joints. These parameters such as: (a) joint geometry (b) joint configuration (c) loading condition (d) fastening parameters and (e) material parameters. The scope of the project is to examine the influence of certain factors on the strength of bolted joints in [0/90]4s GFRP composites. These features include the tightening torque (T= 15, 20, 25 & 30 Nm). The mechanical properties (Tensile & Compressive) of GFRP laminates have been examined experimentally and theoretically. From the investigational study, it is found that bolted joint and bolted - bonded joint with 6 mm diameter, 25 Nm tightening torque has the extreme strength. Most of the test specimens failed in (a) Bearing failure (b) Net tension failure (c) Shear out failure (d) Cleavage tension failure.Keywords
This publication has 15 references indexed in Scilit:
- On the use of quasi-dynamic modeling for composite material structures: Analysis of adhesively bonded joints with midplane asymmetry and transverse shear deformationComposites Science and Technology, 2006
- Progressive Damage Modeling of an Adhesively Bonded Unidirectional Composite Single-lap Joint in Tension at the Mesoscale LevelJournal of Thermoplastic Composite Materials, 2006
- Tensile failure of adhesively bonded CFRP composite scarf jointsMaterials Science and Engineering: B, 2006
- Failure analysis of woven laminated glass–vinylester composites with pin-loaded holeComposite Structures, 2006
- Progressive failure analysis of pin-loaded carbon–epoxy woven composite platesComposites Science and Technology, 2002
- A damage zone model for the failure analysis of adhesively bonded jointsInternational Journal of Adhesion and Adhesives, 1998
- A statistical approach to the analysis of ultimate strengths of bolted joints in laminated compositesComposites Science and Technology, 1996
- Strength and failure modes of bonded single lap joints between cross-ply adherendsComposites, 1993
- Stress and strength analysis of composite joints using direct boundary element methodComposite Structures, 1993
- Stresses in Adhesively Bonded Joints: A Closed-Form SolutionJournal of Composite Materials, 1981