2D Materials-Based Fiber Optic SPR Biosensor for Cancer Detection at 1550 nm
- 7 September 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 21 (21) , 23957-23964
Abstract
Two-dimensional (2D) materials-based fiber-optic surface plasmon resonance (SPR) sensor is proposed to diagnose the different cancers at the wavelength of 1550 nm. In this work, five types of cancerous cell lines such as Jurkat, HeLa, PC12, MDA-MB-231, MCF7, and normal cell lines are considered for analysis. The power loss through proposed SPR sensor is maximum at a specific angle ${\theta }_{\textit {SPR}}$ . Resonance angle ${\theta }_{\textit {SPR}}$ shift to another angle for different cancerous cell lines. The angular shift and power loss of different cancerous cells are different from their normal cells due to the different refractive indices (RIs) of each cell. The proposed work is helpful in the detection of different types of cancer such as blood, cervical, Adrenal Glands and Breast Cancer by measuring the angular shift in peak power loss. For angular power loss calculations, transfer matrix method (TMM) is used. The sensor structure consists of fiber core, clad, metal layer, and 2D material layer. In 2D material, role of MoS 2 and graphene are investigated on the performance of sensor. Further, three structures such as (i) probe 1: SiO 2 -perfluorinated (PF)-Ag (ii) probe 2: SiO 2 -PF-Ag-MoS 2 , and (iii) probe 3: SiO 2 -PF-Ag-graphene are designed and investigated in detail. Calculated values of a figure of merit (FOM) for probe 2, probe 1, and probe 3 sensor structure are 6654.54 RIU −1 , 4645.21 RIU −1 , and 832.88 RIU −1 , respectively. Sensitivity and limit of detection (LoD) are also calculated from power loss spectrum. Probe 2 provides maximum FOM in all and exhibits three times larger FOM than earlier reported cancer cell sensors. The calculated LoD in case of probe 2 for Jurkat, HeLa, PC12, MDA-MB-231, MCF7 are 0.4550 −5 , 0.4510 −5 , 0.4440 −5 , 0.4350 −5 and 0.430 −5 respectively with maximum sensitivity of 232.33 deg./RIU. Thus, LoD of the proposed sensor is quite low that makes it better than most of the recently reported SPR based fiber-optic sensors. The proposed fiber optic SPR sensor with high FOM and low LoD is a suitable candidate for the early diagnosis of different types of cancers.Keywords
Funding Information
- Science and Engineering Research Board, India (TAR/2018/000051)
This publication has 34 references indexed in Scilit:
- Exploiting the biological windows: current perspectives on fluorescent bioprobes emitting above 1000 nmNanoscale Horizons, 2016
- Cell refractive index for cell biology and disease diagnosis: past, present and futureLab on a Chip, 2015
- Comparison of Gold and Silver/Gold Bimetallic Surface for Highly Sensitive Near-infrared SPR Sensor at 1550 nmPlasmonics, 2012
- Broadband graphene polarizerNature Photonics, 2011
- Designing polymer surfaces via vapor depositionMaterials Today, 2010
- Surface Plasmon Resonance Sensors for Detection of Chemical and Biological SpeciesChemical Reviews, 2008
- Determining refractive index of single living cell using an integrated microchipSensors and Actuators A: Physical, 2007
- Fiber-Optic Chemical Sensors and BiosensorsAnalytical Chemistry, 2006
- Optical properties of metallic films for vertical-cavity optoelectronic devicesApplied Optics, 1998
- Interspecimen Comparison of the Refractive Index of Fused Silica*,†Journal of the Optical Society of America, 1965