Epoxy-embedded versus nonembedded TEM examination of the resin-dentin interface
Authors:
- 1 May 1997
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 35 (2) , 191-197
Abstract
When transmission electron microscopy (TEM) is used to evaluate resin‐dentin interface specimens for completeness of hybridization, the epoxy resin embedding medium that normally facilitates ultrathin sectioning may produce a secondary or artifactual hybrid layer. This secondary hybrid layer, composed of epoxy resin rather than adhesive resin, may fill the pores that remain as evidence of incomplete resin infiltration, obscuring the fact that they ever existed. In this study, resin‐dentin interfaces produced by two dentin adhesive systems, Optibond (OPTI, Kerr) and Scotch‐bond Multi‐Purpose (SBMP, 3M), were comparatively investigated by TEM in epoxy‐embedded and nonembedded non‐demineralized sections. The hypothesis advanced was that no difference in ultramorphology of the hybrid layer would result from either specimen preparation method. The two adhesive systems were applied to four mid‐coronal dentin disks per manufacturer's instructions. One half of each sample was processed following common procedures for TEM sample preparation with epoxy embedding, whereas the other half was not embedded but instead immersed in hexamethyldisilazane (HMDS), dried and mounted so that it protruded from a base of cold‐cure acrylic resin. Each sample was then sectioned using a diamond knife in an ultramicrotome. With either means of preparation, a hybrid layer with a relatively uniform electron density and a loose collagen fibril arrangement with electron lucent interfibrillar channels was formed by OPTI. At the base of the hybrid layer, collagen fibrils were anchored in the underlying unaffected dentin, and no microporosities or gaps were observed. Similarly, whether SBMP was embedded or nonembedded, it was found to have a hybrid layer of variable electron density and an electron dense phase localized at the surface of the hybrid layer. No porosities were evident at the base of the hybrid layer. Thus, with either of the two adhesive systems, no ultrastructural difference in hybrid layer formation was observed between epoxy‐embedded and nonembedded sections, and no direct evidence of ineffective resin‐infiltration of the demineralized collagen scaffold was found. © 1997 John Wiley & Sons, Inc.Keywords
This publication has 17 references indexed in Scilit:
- Clinical Status of Ten Dentin Adhesive SystemsJournal of Dental Research, 1994
- The Effects of Ion Sputtering on Dentin and its Relation to Depth ProfilingJournal of Dental Research, 1994
- Bond strength and microleakage of current dentin adhesivesDental Materials, 1994
- The influence of age and depth of dentin on bondingDental Materials, 1994
- Morphology of coupling sites between bonding agents and dentine in vivo and in vitroJournal of Dentistry, 1993
- Comparative SEM and TEM Examination of the Ultrastructure of the Resin-Dentin Interdiffusion ZoneJournal of Dental Research, 1993
- Morphological Aspects of the Resin-Dentin Interdiffusion Zone with Different Dentin Adhesive SystemsJournal of Dental Research, 1992
- Effect of HEMA on bonding to dentinDental Materials, 1992
- The promotion of adhesion by the infiltration of monomers into tooth substratesJournal of Biomedical Materials Research, 1982
- A Simple Method of Increasing the Adhesion of Acrylic Filling Materials to Enamel SurfacesJournal of Dental Research, 1955