Impact of Platinum Loading and Layer Thickness on Cathode Catalyst Degradation in PEM Fuel Cells
Open Access
- 1 February 2023
- journal article
- research article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 170 (2) , 024506
Abstract
In this work we investigate the effect of platinum loading and layer thickness on cathode catalyst degradation by a comprehensive in situ and STEM-EDS characterization. To decouple the effect of the platinum loading and layer thickness from each other, the experiments were categorized in two sets, each with cathode loadings varying between 0.1 and 0.4 mgPt cm−2: (i) Samples with a constant Pt/C ratio and thus varying layer thickness, and (ii) samples with varying Pt/C ratios, achieved by dilution with bare carbon, to maintain a constant layer thickness at different platinum loadings. Every MEA was subjected to an accelerated stress test, where the cell was operated for 45,000 cycles between 0.6 and 0.95 V. Regardless of the Pt/C ratio, a higher relative loss in electrochemically active surface area was measured for lower Pt loadings. STEM-EDS measurements showed that Pt was mainly lost close to the cathode—membrane interface by the concentration driven Pt2+ ion flux into the membrane. The size of this Pt-depletion zone has shown to be independent on the overall Pt loading and layer thickness, hence causing higher relative Pt loss in low thickness electrodes, as the depletion zone accounts for a larger fraction of the catalyst layer.Keywords
Funding Information
- National Science Foundation: PFI-RP award (1919280)
- Bundesministerium für Verkehr und Digitale Infrastruktur (03B11018A)
- Bundesministerium für Forschung, Technologie und Raumfahrt (03EW0011A)
This publication has 42 references indexed in Scilit:
- Impact of Platinum Loading and Catalyst Layer Structure on PEMFC PerformanceJournal of the Electrochemical Society, 2013
- PEMFC Catalyst Layers: The Role of Micropores and Mesopores on Water Sorption and Fuel Cell ActivityACS Applied Materials & Interfaces, 2011
- Analysis of Oxygen-Transport Diffusion Resistance in Proton-Exchange-Membrane Fuel CellsJournal of the Electrochemical Society, 2011
- On the Micro-, Meso-, and Macroporous Structures of Polymer Electrolyte Membrane Fuel Cell Catalyst LayersACS Applied Materials & Interfaces, 2010
- Measurement of Oxygen Transport Resistance in PEM Fuel Cells by Limiting Current MethodsJournal of the Electrochemical Society, 2009
- Review: Durability and Degradation Issues of PEM Fuel Cell ComponentsFuel Cells, 2008
- Instability of Supported Platinum Nanoparticles in Low-Temperature Fuel CellsTopics in Catalysis, 2007
- Experimental Method to Determine the Mass Transport Resistance of a Polymer Electrolyte Fuel CellJournal of the Electrochemical Society, 2006
- Measurement of Catalyst Layer Electrolyte Resistance in PEFCs Using Electrochemical Impedance SpectroscopyJournal of the Electrochemical Society, 2005
- Kinetic Model of Platinum Dissolution in PEMFCsJournal of the Electrochemical Society, 2003