Engineering estimates of impurity fluxes on the ITER port plugs
- 19 August 2016
- journal article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 56 (10) , 106027
Abstract
Predictions of impurity fluxes are required for design analysis of the ITER optical diagnostics. In the present paper a simplified model is proposed for calculation of the neutral impurity fluxes on the recessed surfaces which are not in direct contact with plasma. The method is based on the Monte-Carlo simulation of the neutral particles transport in prescribed and fixed plasma background. The plasma parameters are projected from experimental observations, scalings and ITER modelling results. Blobs are approximated as stationary hot species. Results of 2D simulations with toroidally uniform wall and of the ‘2.5D model’ are presented. In this latter the 3D geometry of ports is implemented, but details of the incident ion flux distribution on the first wall panels are neglected. The calculated worst case gross deposition rate of Be in the middle of the port plug faces reaches almost 0.1 nm s−1. At the same time, the obtained Be erosion to deposition ratio at those locations is always larger than 5, indicating high probability of net erosion conditions there.Keywords
This publication has 24 references indexed in Scilit:
- Status and physics basis of the ITER divertorPhysica Scripta, 2009
- Spectral effects on fast wave core heating and current driveNuclear Fusion, 2009
- Spatial structure of scrape-off-layer filaments near the midplane and X-point regions of Alcator-C-ModJournal of Nuclear Materials, 2009
- Diagnostic mirrors for ITER: A material choice and the impact of erosion and deposition on their performanceJournal of Nuclear Materials, 2007
- Formulation of Boundary Conditions for the Unmagnetized Multi-Ion-Component Plasma SheathContributions to Plasma Physics, 2006
- Far scrape-off layer and near wall plasma studies in DIII-DJournal of Nuclear Materials, 2005
- Multi-machine comparisons of H-mode separatrix densities and edge profile behaviour in the ITPA SOL and Divertor Physics Topical GroupJournal of Nuclear Materials, 2004
- Finite element modelling of transport in a tokamak edge and divertorPlasma Physics and Controlled Fusion, 2002
- Angular dependence of power in the DIII-D divertorNuclear Fusion, 1991
- Investigation of the fluxes to a surface at grazing angles of incidence in the tokamak boundaryPlasma Physics and Controlled Fusion, 1990