Real-time ML estimation of very frequency selective multipath channels
Authors:
- 4 December 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2045-2050 vol.3
Abstract
It is shown that the inverse filter is a good solution for estimating multipath channels when using binary sequences as the input signal. It is a maximum-likelihood estimator which enables the utilization of aperiodic sequences (bursts). Therefore, it is well suited for estimating very-frequency-selective channels. Since the channel is only occupied during short time intervals, it maintains compatibility with other services when measuring in occupied frequency bands. A practical realization shows that inverse-filter-based estimation techniques are well suited for implementing real-time channel sounders. The inverse filter is realized in SAW (surface acoustic wave) techniques. The implementation loss of 2.5 to 3.5 dB for the POP (peak/off peak) ratio shows that its realization is not particularly critical. The sounder estimates either full impulse responses or statistical parameters at a rate of 9 or 2.2 impulse responses per second, respectively. Relevant parameters characterizing the mobile radio channel are proposed.Keywords
This publication has 4 references indexed in Scilit:
- Synthesis of SAW-correlator with integrated spectrum-shaping2003
- Power delay profiles measured in mountainous terrain (radiowave propagation)2003
- 900 MHz multipath propagation measurements in four United States citiesElectronics Letters, 1989
- Sieves for low autocorrelation binary sequencesIEEE Transactions on Information Theory, 1977