The effect of filler type (tungsten carbide, zinc oxide) and content on the mechanical and wear behavior of jute/flax reinforced epoxy hybrid composites: Experimental and artificial neural network analysis
Open Access
- 1 April 2025
- journal article
- Published by Wiley in Polymer Composites
- Vol. 46 (9) , 8700-8719
Abstract
The application of natural fiber‐reinforced composite (NFRC) is growing rapidly in various industrial sectors, such as automotive, packaging, and construction materials, because of its affordability and excellent mechanical properties. This study investigates the effects of tungsten carbide (WC) and zinc oxide (ZnO) filler content on the mechanical and wear performance of jute/flax‐reinforced hybrid composites. WC filler enhanced the tensile stress of composites more effectively than ZnO filler. Adding 1% WC and 1.5% ZnO enhanced the tensile strength of the unfilled composite by 41% and 24%, respectively. Wear tests conducted under various parameters revealed that increasing the load reduced the coefficient of friction (COF) but increased the wear rate and mass loss for both neat and filled composites. The lowest COF values were observed in WC‐filled composites. It was observed that ZnO and WC‐filled composites exhibited less matrix deformation, pitting, and porosity compared to neat composites. Impact resistance improved with the addition of ZnO and WC fillers, with the impact strength of 1.5% WC‐filled hybrid composites increasing from 4.5 to 10.3 J/m2. The experimental wear rate and COF closely matched the predicted values acquired from the model, demonstrating the success of the artificial neural network (ANN) model in precisely estimating COF and wear rate values.Highlights: The addition of fillers improved the mechanical properties of hybrid composites. Exceeding optimum filler ratio negatively affects the mechanical properties. Adding fillers has improved the wear resistance of jute/flax composites. Artificial neural network model strongly correlates with experimental results. Infrared spectroscopy analysis validated the interaction between filler and epoxy.Keywords
This publication has 89 references indexed in Scilit:
- Parametric appraisal and wear prediction of red brick dust filled epoxy composites using finite element methodMaterialwissenschaft und Werkstofftechnik, 2024
- Hybridization effect on the mechanical properties of basalt fiber reinforced ZnO modified epoxy compositesPolymer Composites, 2022
- Acoustic performance of natural fiber reinforced polymer composites: Influencing factors, future scope, challenges, and applicationsPolymer Composites, 2021
- Pongamia pinnata shell powder filled sisal/kevlar hybrid composites: Physicomechanical and morphological characteristicsPolymer Composites, 2021
- Processing and wear response study of glass‐polyester composites with waste marble dust as particulate fillerPolymer Composites, 2020
- RETRACTED: Effect of surface modified WO3 nanoparticle on the epoxy coatings for the adhesive and anticorrosion properties of mild steelJournal of Applied Polymer Science, 2019
- Optimizing Wear Behavior of Epoxy Composites Using Response Surface Methodology and Artificial Neural NetworksPolymer Composites, 2018
- Hybrid neural network‐based prediction model for tribological properties of polyamide6‐based friction materialsPolymer Composites, 2015
- Nanofiller‐reinforced polymer nanocompositesPolymers for Advanced Technologies, 2008
- Recent developments in chemical modification and characterization of natural fiber‐reinforced compositesPolymer Composites, 2007