Synthesis of PbTe Intermetalic Compound by Mechanical Alloying
- 1 October 2010
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 660-661, 347-352
Abstract
The formation of PbTe intermetallic compound by mechanical alloying (MA) has been investigated. The elemental starting materials were 99.5% pure lead and tellurium, with a sieve size of 80 and 200 mesh, respectively. A SPEX 8000 shaker milling was used to perform the MA, using WC balls as milling media in a cylindrical hardened tool steel vial. X-ray diffraction analysis was performed with a profile-fitting program, to evaluate time evolution of the alloy formation. An exotermical reaction occurs on PbTe formation, with entalphy H= - 16.3 Kcal/mol. The *T value is confirmed by the heat exchange equation *Q = |*Hf | =* i (mici ) *T, where the summation comprises the mass and specific heat of vial, balls and powder material. For the standard milling conditions employed, the PbTe formation occurs at aproximately 90 seconds of milling, when using charge ratios between 3:1 and 7.5:1. However, for lower charge ratios (8:1 to 10:1), isolated reactions at the mixture occurs, but the amount of material is not enough to raise the temperature of adjacent regions, and the propagation of the reaction is avoided. There is therefore a minimum amount of powder (“critical mass”), and below this value the reaction will not be self-sustained.Keywords
This publication has 23 references indexed in Scilit:
- Enhanced Thermoelectric Figure-of-Merit in p-Type Nanostructured Bismuth Antimony Tellurium Alloys Made from Elemental ChunksNano Letters, 2008
- New Directions for Low‐Dimensional Thermoelectric MaterialsAdvanced Materials, 2007
- Thermal conductivity modeling of periodic two-dimensional nanocompositesPhysical Review B, 2004
- Evidence for self-sustained MoSi2 formation during room-temperature high-energy ball milling of elemental powdersJournal of Materials Research, 1993
- The mechanism of mechanical alloying of MoSi2Journal of Materials Research, 1993
- Defect-induced melting and solid-state amorphizationNature, 1992
- Thermodynamic and kinetic aspects of the crystal to glass transformation in metallic materialsProgress in Materials Science, 1986
- Mechanical AlloyingAnnual Review of Materials Science, 1983
- Phonon scattering at grain boundaries in heavily doped fine-grained silicon–germanium alloysNature, 1981
- The vacuum hot-pressing of germanium and silicon-germanium alloysJournal of Physics D: Applied Physics, 1977