Low-loss propagation in Cr^4+:YAG double-clad crystal fiber fabricated by sapphire tube assisted CDLHPG technique
- 1 August 2008
- journal article
- Published by Optica Publishing Group in Optics Express
- Vol. 16 (16) , 12264-12271
Abstract
Cr4+:YAG double-clad crystal fiber with an uniform 10-μm core was fabricated by using a sapphire tube as a heat capacitor to stabilize the power fluctuation of the CO2 laser in the co-drawing laser-heated pedestal growth system. The uniformity of the fiber core showed a factor of 3 improvement compared to that without the use of sapphire tube. The variation of the core diameter is within the ±1.35-degree adiabatic criterion and has a autocorrelation length of 1.7 mm. The measured propagation loss is only 0.02 dB/cm. The sapphire tube also reduces the vertical temperature gradient during the crystal fiber growth process so the 10-μm crystal core exhibits a smooth perimeter. The sapphire tube assisted system can be applied to the growth of many other optical crystal materials.Keywords
This publication has 15 references indexed in Scilit:
- Double-clad Cr^4+:YAG crystal fiber amplifierOptics Letters, 2005
- Glass-clad Cr^4+:YAG crystal fiber for the generation of superwideband amplified spontaneous emissionOptics Letters, 2004
- Subwavelength-diameter silica wires for low-loss optical wave guidingNature, 2003
- Broadly tunable Cr4+-doped solid-state lasers in the near infrared and visibleProgress in Quantum Electronics, 2002
- Three-dimensional simulation of facet formation and the coupled heat flow and segregation in Bridgman growth of oxide crystalsJournal of Crystal Growth, 2001
- Design and analysis of completely adiabatic tapered waveguides by conformal mappingJournal of Lightwave Technology, 1997
- The shape of fiber tapersJournal of Lightwave Technology, 1992
- Tapered single-mode fibres and devices. Part 1: Adiabaticity criteriaIEE Proceedings J Optoelectronics, 1991
- Laser-heated miniature pedestal growth apparatus for single-crystal optical fibersReview of Scientific Instruments, 1984
- Mode Conversion Caused by Surface Imperfections of a Dielectric Slab WaveguideBell System Technical Journal, 1969