An efficient hybrid model for thermal analysis of deep borehole heat exchangers
Authors:
Open Access
- 15 June 2020
- journal article
- research article
- Published by Springer Nature in Geothermal Energy
- Vol. 8 (1) , 1-31
Abstract
The deep borehole heat exchanger (DBHE) shows great potential in seasonal thermal energy storage and its high performance efficiency with smaller land occupancy attracts increasing attention as a promising geothermal energy exploitation technique. With respect to a vertical BHE with extremely long length pipes buried underground, thermal analysis of the unsteady heat transfer process of the system is quite complicated. Due to the high temperature underground, the deeper part of BHE can extract more heat from the rock, which leads to a higher heat extraction rate. The heterogeneous distribution of heat flux density and geothermal gradient cannot be described properly by the existing analytical models. Although a full 3D numerical solution can reflect these features, it always requires high computational resources and presents numerical instabilities. In this paper, we propose a hybrid modeling method with high efficiency to simulate the temperature evolution inside the DBHE, and the heat propagation front in the surrounding rock mass. The temperature evolution inside the DBHE is solved by finite difference schemes, while the heat propagation in the surrounding rock is determined by an analytical formulation of thermal impacted radius. The coupling is achieved via source/sink term by incorporating the heat flux between the DBHE and the surrounding rock. Furthermore, an innovative analytical formulation describing the heat flux density is also presented, which accounts for the key parameters affecting the thermal performance of the DBHE system. Our proposed model is further verified against results with full 3D numerical solution under the same configurations. It is demonstrated that the proposed model can capture the key physical process of the heat transfer problem, while maintaining the calculation accuracy required by the engineering application. Regarding the calculation speed, the model results are around 30 times faster when compared to the full 3D numerical solution.Keywords
Funding Information
- Chinese Academy of Sciences (XDA 21020202)
This publication has 44 references indexed in Scilit:
- A Review of the Modelling of Thermally Interacting Multiple BoreholesSustainability, 2013
- A three-dimensional numerical model of borehole heat exchanger heat transfer and fluid flowGeothermics, 2013
- On Thermally Interacting Multiple Boreholes with Variable Heating Strength: Comparison between Analytical and Numerical ApproachesSustainability, 2012
- Heat-source solutions to heat conduction in anisotropic media with application to pile and borehole ground heat exchangersApplied Energy, 2012
- A moving finite line source model to simulate borehole heat exchangers with groundwater advectionInternational Journal of Thermal Sciences, 2011
- Thermal resistance and capacity models for borehole heat exchangersInternational Journal of Energy Research, 2011
- Reference data sets for vertical borehole ground heat exchanger models and thermal response test analysisGeothermics, 2011
- A computational capacity resistance model (CaRM) for vertical ground-coupled heat exchangersRenewable Energy, 2010
- Vertical-borehole ground-coupled heat pumps: A review of models and systemsApplied Energy, 2010
- Finite line-source model for borehole heat exchangers: effect of vertical temperature variationsGeothermics, 2009