Quenching and Partitioning of Multiphase Aluminum-Added Steels
Open Access
Abstract
The quenching and partitioning response following intercritical annealing was investigated for three lean TRIP-type high-Al steel compositions. Depending on the intercritical austenite fraction following annealing, the steels assumed either a ferrite/martensite/retained austenite microstructure or a multiphase structure with ferritic, bainitic and martensitic constituents along with retained austenite. The amount of retained austenite was found to correlate with the initial quench temperature and, depending on the intercritical annealing condition prior to initial quenching, with the uniform and ultimate elongations measured in tensile testing.Keywords
This publication has 24 references indexed in Scilit:
- Carbon and strain partitioning in a quenched and partitioned steel containing ferriteActa Materialia, 2019
- Crystallography and mechanical properties of intercritically annealed quench and partitioned high-aluminum steelMaterials Characterization, 2019
- Crystallography, Morphology, and Martensite Transformation of Prior Austenite in Intercritically Annealed High-Aluminum SteelMetallurgical and Materials Transactions A, 2018
- Microstructural evolution during quenching and partitioning of 0.2C-1.5Mn-1.3Si steels with Cr or Ni additionsActa Materialia, 2018
- Effects of silicon content and intercritical annealing on manganese partitioning in dual phase steelsJournal of Iron and Steel Research International, 2010
- Bainite transformation of low carbon Mn–Si TRIP-assisted multiphase steels: influence of silicon content on cementite precipitation and austenite retentionMaterials Science and Engineering: A, 1999
- Pearlite to austenite transformation in an Fe–2.6Cr–1C alloyActa Materialia, 1999
- The Influence of the Substitution of Si by Al on the Properties of Cold Rolled C-Mn-Si TRIP Steels.ISIJ International, 1999
- Formation of austenite in 1.5 pct Mn steelsMetallurgical Transactions A, 1981
- Austenitization kinetics of pearlite and ferrite aggregates in a low carbon steel containing 0.15 wt pct CMetallurgical Transactions A, 1981