Formation Characteristics of Pt‐Ni Alloy Nanoparticles Fabricated by Nanolamination of Atomic Layer Deposition in Hydrogen
Abstract
Forced‐flow atomic layer deposition nanolamination is employed to fabricate Pt‐Ni nanoparticles on XC‐72, with the compositions ranging from Pt94Ni6 to Pt67Ni33. Hydrogen is used as a co‐reactant for depositing Pt and Ni. The growth rate of Pt is slower than that using oxygen reactant, and the growth exhibits preferred orientation along the (111) plane. Ni shows much slower growth rate than Pt, and it is only selectively deposited on Pt, not on the substrate. Higher ratios of Ni would hinder subsequent stacking of Pt atoms, resulting in lower overall growth rate and smaller particles (1.3–2.1 nm). Alloying of Pt with Ni causes shifted lattice that leads to larger lattice parameter and d‐spacing as Ni fraction increases. From the electronic state analysis, Pt 4f peaks are shifted to lower binding energies with increasing the Ni content, suggesting charge transfer from Ni to Pt. Schematic of the growth behavior is proposed. Most of the alloy nanoparticles exhibit higher electrochemical surface area and oxygen reduction reaction activity than those of commercial Pt. Especially, Pt83Ni17 and Pt87Ni13 show excellent mass activities of 0.76 and 0.59 A mgPt−1, respectively, higher than the DOE target of 2025, 0.44 A mgPt−1.Keywords
Funding Information
- Ministry of Science and Technology, Taiwan (MOST 109‐2221‐E‐007‐060‐MY3)
- National Science and Technology Council (NSTC 112‐2211‐E‐007‐041‐MY2, NSTC 112‐2811‐E‐007‐012‐MY2)
This publication has 46 references indexed in Scilit:
- Catalyst Development for High‐Temperature Polymer Electrolyte Membrane Fuel Cell (HT‐PEMFC) ApplicationsAdvanced Materials, 2023
- Milestones of Electrocatalyst Development for Direct Alcohol Fuel CellsAdvanced Sustainable Systems, 2023
- Formation Mechanism and Bandgap Reduction of GaN–ZnO Solid‐Solution Thin Films Fabricated by Nanolamination of Atomic Layer DepositionAdvanced Materials, 2023
- Zinc Intercalated Lattice Expansion of Ultrafine Platinum–Nickel Oxygen Reduction Catalyst for PEMFCAdvanced Functional Materials, 2022
- Low‐Pt NiNC‐Supported PtNi Nanoalloy Oxygen Reduction Reaction Electrocatalysts—In Situ Tracking of the Atomic Alloying ProcessAngewandte Chemie International Edition, 2022
- Compositionally tuned magnetron co-sputtered PtxNi100-x alloy as a cathode catalyst for proton exchange membrane fuel cellsApplied Surface Science, 2020
- Phase and Composition Tuning of 1D Platinum‐Nickel Nanostructures for Highly Efficient ElectrocatalysisAdvanced Functional Materials, 2017
- Mechanistic studies for depositing highly dispersed Pt nanoparticles on carbon by use of trimethyl(methylcyclopentadienyl)platinum(IV) reactions with O2 and H2Journal of Nanoparticle Research, 2015
- Extremely Stable Platinum Nanoparticles Encapsulated in a Zirconia Nanocage by Area‐Selective Atomic Layer Deposition for the Oxygen Reduction ReactionAdvanced Materials, 2014
- Atomic Layer Deposition of Platinum Nanoparticles on Carbon Nanotubes for Application in Proton‐Exchange Membrane Fuel CellsSmall, 2009