Periosteal bone formation stimulated by externally induced bending strains
Authors:
Open Access
- 1 August 1994
- journal article
- research article
- Published by Oxford University Press (OUP) in Journal of Bone and Mineral Research
- Vol. 9 (8) , 1143-1152
Abstract
The rat tibia four-point bending model is a new mechanical loading model in which force is applied through external pads to the rat lower limb. The advantages of the model are controlled force application to a well-defined bone, noninvasive external loading, and the addition of loads to normal daily activity. A disadvantage of the model is that the pads create local pressure on the leg at the contact sites. This study examined the differences in tibial response to bending strains and to local pressure under the pads. A total of 30 adult Sprague-Dawley rats were randomized into three external loading groups: bending, cyclic pressure, and static pressure. The right leg of each rat was externally loaded to create either bending or local pressure without bending; the left leg served as a control. Strains on the lateral surface averaged 1200 μϵ in compression during bending load application and <200 μϵ in compression during pressure loading. Histomorphometric data were collected from three regions: the maximal bending region, under the loading pads, and outside the maximal bending region. In the maximal bending region, bending loads created greater mineral apposition rate (MAR) on the lateral surface and greater MAR and formation surface on the medial surface of loaded than control tibiae. The region under the bending pad was exposed to similar bending strains and showed the same pattern of increased MAR as sections from the maximal bending region. Cyclic pressure had no effect on periosteal MAR or formation surface. Static pressure increased MAR only on the lateral tibial surface. Bending stimulates bone formation in regions with the highest bending strains. Similar forces applied only in the form of pressure loading do not stimulate tibial formation either at the contact site or between loading pads. These results suggest that externally applied forces of moderate magnitude stimulate bone formation primarily as a result of increased bending strains, not local pressure at the contact site.Keywords
Funding Information
- National Research Service Award (AR08144)
- Health Future Foundation (AR39221)
- National Institutes of Heath
This publication has 26 references indexed in Scilit:
- Bone response to alternate-day mechanical loading of the rat tibiaJournal of Bone and Mineral Research, 1994
- Mechanical loading thresholds for lamellar and woven bone formationJournal of Bone and Mineral Research, 1994
- Effect of ovariectomy on bone response to in vivo external loadingJournal of Bone and Mineral Research, 1993
- Structural changes in rat bone subjected to long-term, in vivo mechanical loadingBone, 1992
- A noninvasive, in vivo model for studying strain adaptive bone modelingBone, 1991
- Local bone mineral response to brief exercise that stresses the skeleton.BMJ, 1989
- The effects of altered strain environments on bone tissue kineticsBone, 1989
- Bone histomorphometry: Standardization of nomenclature, symbols, and units: Report of the asbmr histomorphometry nomenclature committeeJournal of Bone and Mineral Research, 1987
- Regulation of bone mass by mechanical strain magnitudeCalcified Tissue International, 1985
- Mechanically adaptive bone remodellingJournal of Biomechanics, 1982