Application of a direct laser melting process for fabricating a micropattern in bipolar plates used in direct methanol fuel cells
- 24 August 2011
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 225 (10) , 1784-1791
Abstract
Direct laser melting (DLM) technology is applied to fabricate the micropattern of bipolar plates in a direct methanol fuel cell (DMFC). For the micropatterning, a DLM process with 316L stainless steel (SS316L) powder has been used. For the target point of 1 mm melt height, the DLM process conditions are optimized and an eight-layer structure is successfully formed. The performance of a bipolar plate made by the DLM micropatterning is compared with a numerical control (NC)-machined bipolar plate. For the DLM micropatterned bipolar plate, the kinetic energy in the fuel causes a more rapid chemical reaction due to the increased surface area of rough side walls. The smaller fluid rate loss enhances circulation of the fluid and, consequently, the efficiency of the micropatterned bipolar plate made by the DLM process is significantly improved. Furthermore, the use of SS316L powder material as a micropatterned material reduces the fabrication cost as well as size of the fuel cell stack.Keywords
This publication has 12 references indexed in Scilit:
- Experimental study on the characterization of airflow effect on the direct methanol fuel cellRenewable Energy, 2009
- Experimental investigation into selective laser melting of austenitic and martensitic stainless steel powder mixturesProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- Mass transport phenomena in direct methanol fuel cellsProgress in Energy and Combustion Science, 2009
- DMFC performance and methanol cross-over: Experimental analysis and model validationJournal of Power Sources, 2008
- Parametric analysis of the selective laser melting processApplied Surface Science, 2007
- Rebuilding of metal components with laser cladding formingApplied Surface Science, 2006
- Development of a small DMFC bipolar plate stack for portable applicationsJournal of Power Sources, 2006
- Performance of DMFC with SS 316 bipolar/end platesJournal of Power Sources, 2006
- Development of micro direct methanol fuel cells for high power applicationsJournal of Power Sources, 2005
- Direct additive laser manufacturing using gas- and water-atomised H13 tool steel powdersThe International Journal of Advanced Manufacturing Technology, 2004