The Influence of Grain Size Determination Method on Grain Growth Kinetics Analysis
- 3 May 2015
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 17 (11) , 1598-1607
Abstract
The full‐width at half‐maximum (FWHM), integral width (IntW), and Scherrer methodologies were used jointly with X‐ray diffraction (XRD) peak broadening and transmission electron microscopy (TEM) data to provide insight into the mechanisms that govern grain growth behavior in an Al 5083‐B4C nanocomposite. Grain growth kinetics were studied by fitting the appropriate grain size data from the three XRD‐based methods to the well‐known Burke equation. Variations observed in the absolute grain sizes calculated from different methods were in agreement with previous studies. In spite of these variations, consistent grain growth trends were observed, which resulted in relatively similar Arrhenius plots indicating two grain growth regimes. Consequently, the applicability as well as any relevant uncertainties within each method are described and discussed.Keywords
This publication has 33 references indexed in Scilit:
- Influence of Nitrogen Content on Thermal Stability and Grain Growth Kinetics of Cryomilled Al NanocompositesMetallurgical and Materials Transactions A, 2011
- Microstructural features influencing the strength of Trimodal Aluminum Metal-Matrix-CompositesComposites Part A: Applied Science and Manufacturing, 2010
- Cryomilled nanostructured materials: Processing and propertiesMaterials Science and Engineering: A, 2008
- Thermal stability in bulk cryomilled ultrafine-grained 5083 Al alloyMetallurgical and Materials Transactions A, 2006
- A tri-modal aluminum based composite with super-high strengthScripta Materialia, 2005
- Thermal stability of nanostructured Al93Fe3Cr2Ti2 alloys prepared via mechanical alloyingActa Materialia, 2003
- Mechanical properties of an ultrafine-grained Al-7.5 Pct Mg alloyMetallurgical and Materials Transactions A, 2003
- High grain size stability of nanocrystalline Al prepared by mechanical attritionJournal of Materials Research, 2001
- Thermal Stability of Nanocrystalline MaterialsMaterials Science Forum, 1996
- The Deformation and Ageing of Mild Steel: III Discussion of ResultsProceedings of the Physical Society. Section B, 1951