Design and Development of a Repetitive Bending Tester for Bending Deformation in Textile Fabrics and Bonded Joints
- 29 July 2022
- journal article
- research article
- Published by ASTM International in Journal of Testing and Evaluation
- Vol. 50 (5) , 2529-2537
Abstract
It is critical to investigate the technical performance of non-stitch joining methods that have become prevalent recently. While examining the bonding strength and the factors that affect the strength of adhesive bonding in textiles, a bending test device was designed and produced to investigate the repetitive bending deformation. The novel test device provides bending deformation and tensile stress to the fabrics at different angles with its oscillating motion. The effects of repetitive bending deformation on fabric strength and adhesive bonding strength were investigated. The experimental analysis showed that repetitive bending deformation did not have a significant effect on the tensile strength of cotton/polyester blend and cotton fabrics. However, strength loss was observed in polyester fabric and cotton/elastane blended fabric samples. Moreover, significant reductions in bonded textile joint strength were observed even in the case of much less repetitive bending exposure.Keywords
Funding Information
- Süleyman Demirel University Scientific Research Committee (TÜBİTAK BİDEB)
- Süleyman Demirel University Scientific Research Committee (TÜBİTAK BİDEB)
This publication has 7 references indexed in Scilit:
- Mechanical properties of textile reinforced concrete under chloride wet-dry and freeze-thaw cycle environmentsCement and Concrete Composites, 2019
- Out-of-plane response of masonry walls strengthened using textile-mortar systemConstruction and Building Materials, 2018
- Influence of the fabric construction parameters and roving type on the tensile property retention of high-performance rovings in warp-knitted reinforced fabrics and cement-based compositesJournal of Industrial Textiles, 2016
- A new apparatus to measure the effect of temperature and light on the bending fatigue properties of Kevlar 49 and PBO fibersPolymer Testing, 2014
- Experimental Study of Bending Behaviour of ReinforcementsExperimental Mechanics, 2009
- A New Method of Evaluating Spherical Fabric DeformationTextile Research Journal, 1999
- The Bending Fatigue of FibresThe Journal of the Textile Institute, 1977