Correlating Deposition Parameters with Structure and Properties of Nanoscale Multilayer (TiSi)N/CrN Coatings
Authors:
- Vyacheslav M. BeresnevVBVyacheslav M. Beresnev
- Olga V. MaksakovaOMOlga V. Maksakova
- Serhiy V. LytovchenkoSLSerhiy V. Lytovchenko
- Serhiy A. KlymenkoSKSerhiy A. Klymenko
- Denis V. HorokhDHDenis V. Horokh
- Andrey S. ManohinAMAndrey S. Manohin
- Bohdan O. MazilinBMBohdan O. Mazilin
- Volodymyr O. ChyshkalaVCVolodymyr O. Chyshkala
- Vyacheslav A. StolbovoyVSVyacheslav A. Stolbovoy
Open Access
- 2 June 2022
- journal article
- research article
- Published by V. N. Karazin Kharkiv National University in East European Journal of Physics
- No. 2,p. 112-117
Abstract
Multilayer (TiSi)N/CrN coatings were fabricated through vacuum-arc deposition by applying the arc currents of (100 ÷ 110) A on TiSi cathode and (80 ÷ 90) A on Cr cathode, negative bias potential connected to the substrate holder of –(100 ÷ 200) V and reactive gas pressure of (0.03 ÷ 0.6) Pa. Applying a negative bias voltage on substrates enhanced the ion bombardment effect, which affected the chemical compositions, phase state, mechanical and tribological properties of (TiSi)N/CrN coatings. Obtained results indicated that (TiSi)N/CrN coatings with Si content ranging from 0.53 to 1.02 at. % exhibited a high hardness level of (22.1 ÷ 31.1) GPa accompanied with a high Young’s modulus of (209 ÷ 305) GPa, H/E* level of (0.080 ÷ 0.100), H3/E*2 level of (0.15 ÷ 0.33) GPa, and the friction coefficient of 0.35. Values of critical loads at dynamic indentation, changes in friction coefficient and level of acoustic emission signal evidence the high adhesive strength of (TiSi)N/CrN coatings, which allows recommending them to increase cutting tool performance.Keywords
This publication has 10 references indexed in Scilit:
- Microstructure and tribological properties of CrN and CrSiCN coatingsSurface and Coatings Technology, 2010
- Structures and properties of hard and superhard nanocomposite coatingsPhysics-Uspekhi, 2009
- Mechanical and tribological properties of multilayered TiSiN/CrN coatings synthesized by a cathodic arc deposition processSurface and Coatings Technology, 2008
- Nanostructured Coatings2006
- Nanocomposite Ti–Si–N, Zr–Si–N, Ti–Al–Si–N, Ti–Al–V–Si–N thin film coatings deposited by vacuum arc depositionSurface and Coatings Technology, 2005
- Different approaches to superhard coatings and nanocompositesThin Solid Films, 2005
- Physical and mechanical properties of sputtered Ta–Si–N films with a high (⩾40 at %) content of SiJournal of Vacuum Science & Technology A, 2004
- Localized deformation of multicomponent thin filmsThin Solid Films, 2002
- Industrial applications of CrN (PVD) coatings, deposited at high and low temperaturesSurface and Coatings Technology, 1997
- A review of adhesion test methods for thin hard coatingsJournal of Vacuum Science & Technology A, 1986