Testing Logic Cores using a BIST P1500 Compliant Approach: A Case of Study
Authors:
- G. MaseraGMG. Masera
- F. QuaglioFQF. Quaglio
- M.S. ReordaM.S. Reorda
- 1 January 2005
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 15301591,p. 228-233
Abstract
In this paper we describe how we applied a BIST-based approach to the test of a logic core to be included in system-on-a-chip (SoC) environments. The approach advantages are the ability to protect the core IP, the simple test interface (thanks also to the adoption of the P1500 standard), the possibility to run the test at-speed, the reduced test time, and the good diagnostic capabilities. The paper reports figures of the achieved fault coverage, the required area overhead, and the performance slowdown, and compares the figures with those for alternative approaches, such as those based on full scan and sequential ATPG.Keywords
All Related Versions
This publication has 12 references indexed in Scilit:
- Macro Testability; The Results of Production Device Applications2005
- Testing a system-on-a-chip with embedded microprocessor2003
- Towards a standard for embedded core test: an example2003
- Testing embedded-core based system chips2002
- Processor-programmable memory BIST for bus-connected embedded memories2002
- Good error-correcting codes based on very sparse matricesIEEE Transactions on Information Theory, 1999
- Using partial isolation rings to test core-based designsIEEE Design & Test of Computers, 1997
- A variance-reduction technique via fault-expansion for fault-coverage estimationIEEE Transactions on Reliability, 1997
- GARDA: a diagnostic ATPG for large synchronous sequential circuits1995
- Low-density parity-check codesIEEE Transactions on Information Theory, 1962