Experimental investigation and finite element analysis of the effects of spindle speed and feed rate on hole quality in micro drilling of Monel 400 alloy
- 8 December 2025
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
- Vol. 240 (1) , 1106-1115
Abstract
Excessive thrust force in micro drilling of difficult to cut materials like Monel alloys poses challenges such as tool breakage, burr formation, and poor hole quality. So optimizing the thrust force is crucial for reducing the tool wear and improving the dimensional accuracy. This work uniquely combines finite element (FE) simulation with experimental validation to evaluate and optimize the effects of spindle speed and feed rate on thrust force, circularity error, and burr formation in micro drilling of Monel 400 alloy. Nine experimental trials and FE simulations with different spindle speeds and feed rates were conducted to evaluate the drilling performance. In addition, three drilling tests were carried out at higher feed rates for assessing its influence on thrust force and drilling quality. Comparison of experimental and simulated thrust forces across varying feed rates and spindle speeds showed strong agreement, with deviations ranging from 1.2% to 5.3%. The influence of cutting parameters on the circularity of holes, burr width, and length at both the entry and exit edges was systematically evaluated. The results demonstrate that higher spindle speeds combined with lower feed rates lead to the lower thrust force (1.703 N), improved hole circularity (entry: 0.6272 mm, exit: 0.6216 mm), and reduced burr formation (entry: 0.27 μ m , exit: 0.16 μ m ). The findings highlight the optimal spindle speed and feed rate to minimize burr and enhance hole quality in micro drilling of Monel 400 alloy.Keywords
This publication has 30 references indexed in Scilit:
- Study on cutting force and surface quality in drilling 2.5D-Cf/SiC compositesDiamond and Related Materials, 2025
- Improving machinability of Ni-based Monel 400 superalloy: a novel thermal-assisted drilling method based induction heatingThe International Journal of Advanced Manufacturing Technology, 2025
- Analysis of thrust force in micro drilling on Nimonic C-263 alloy using finite element simulation and validated with experimentsJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2025
- Chip removal mechanism and hole plugging in backdrilling of high-speed printed circuit boardThe International Journal of Advanced Manufacturing Technology, 2025
- Machining-Induced Damage and Corrosion Behavior of Monel-400 Alloy Under Cryogenic Cooling Conditions: A Sustainable InitiativeInternational Journal of Precision Engineering and Manufacturing-Green Technology, 2024
- Modeling Hole Edge and Burr Formation During Drilling Using LS-DYNA2024
- Investigation of optimal machining Monel 400 superalloy considering carbon emissions using FEM, regression and ANN methodsJournal of Cleaner Production, 2024
- A study on the EDM drilling of reaction-bonded silicon carbide using different electrode materialsThe International Journal of Advanced Manufacturing Technology, 2023
- Experimental study on the effects of cold chamber die casting parameters on high-speed drilling machinability of casted AZ91 alloyJournal of Manufacturing Processes, 2020
- Thermal management of microelectronic devices using micro-hole cellular structure and nanofluidsJournal of Thermal Analysis and Calorimetry, 2018