A Laboratory Investigation of Grid Reinforcements in Clay
Author:
- 1 September 1983
- journal article
- Published by ASTM International in Geotechnical Testing Journal
- Vol. 6 (3) , 112-119
Abstract
The governing criteria for internal stability of reinforced soil require that the soil reinforcement should have adequate factors of safety against tensile fracture and pullout. In terms of total stress the pull-out resistance will be some function of the area of reinforcement embedded in the restraint zone and the soil-reinforcement adhesion that may be related to the undrained shear strength of the soil by an adhesion factor. This factor has been assessed for several types of reinforcement using a direct shear box with the reinforcement inclined across the two halves of the box. These tests showed grid reinforcement to be the most efficient, consequently, subsequent testing, in the form of pull-out and shear box tests with horizontal reinforcement, was restricted to grids. The adhesion factors were found to be markedly dependent on test method with the pull-out test giving the lowest values. An analytical assessment of the results suggests that grid pull-out resistance is a function of the area of grid members normal and parallel to the direction of applied load rather than embedded plan area.Keywords
This publication has 2 references indexed in Scilit:
- Slipping strip analysis of reinforced earthInternational Journal for Numerical and Analytical Methods in Geomechanics, 1978
- Bearing Capacity Analysis of Reinforced Earth SlabsJournal of the Geotechnical Engineering Division, 1975