Removal of SO2 from flue gas using a new semidry flue gas desulfurization process with a powder‐particle spouted bed
Authors:
- 1 April 1999
- journal article
- research article
- Published by Wiley in The Canadian Journal of Chemical Engineering
- Vol. 77 (2) , 356-362
Abstract
A spouted bed of binary particle mixture was applied to a low temperature desulfurization process in order to develop a new type of semidry flue gas desulfurization (FGD) technology. We investigated the effects of operating parameters, such as type of SO2 sorbent, diameter of SO2 sorbent particles, apparent residence time of gas in the bed, approach to saturation temperature and Ca/S molar ratio, on SO2 removal in a bench‐scale powder‐particle spouted bed. We also investigated the utilization rate of SO2 sorbent and ways to enhance the efficiency of SO2 removal and SO2 sorbent utilization. The experimental results showed that SO2 removal is significantly affected by the approach to saturation temperature and Ca/S molar ratio, and that a high SO2 removal efficiency and effective sorbent utilization can be obtained under appropriate operating conditions. Thus, this new simple process of flue gas desulfurization is highly efficient and has little impact on the environment.Keywords
This publication has 21 references indexed in Scilit:
- Desulfurization Characteristics in High-Temperature Powder-Particle Fluidized Bed Desulfurizer.KAGAKU KOGAKU RONBUNSHU, 1998
- Study of modified calcium hydroxides for enhancing SO2 removal during sorbent injection in pulverized coal boilersFuel, 1997
- A New Dry Process for Simultaneous Removal of SO2 and NO from Flue Gas by Powder-particle Fluidized Bed.Journal of The Japan Petroleum Institute, 1997
- Process Development of Effective Semi-Dry Flue Gas Desulfurization by Powder-Particle Spouted Bed.KAGAKU KOGAKU RONBUNSHU, 1996
- Drying of Microparticle Slurry and Salt-Water Solution by a Powder-Particle Spouted Bed.JOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1996
- The use of a circulating fluidized bed absorber for the control of sulfur dioxide emissions by calcium oxide sorbent via in situ hydrationPowder Technology, 1995
- Simultaneous Removals of SO2 and NO in a Powder-particle Fluidized Bed by Using Iron Oxide Dust as Sorbent.Journal of The Japan Petroleum Institute, 1995
- The maximum spoutable bed heights of fine particles spouted with airThe Canadian Journal of Chemical Engineering, 1994
- Effective dry desulfurization by a powder-particle fluidized bed.JOURNAL OF CHEMICAL ENGINEERING OF JAPAN, 1994
- Residence Time Distribution of Fine Particles in a Powder-Particle Fluidized Bed.KAGAKU KOGAKU RONBUNSHU, 1991