Interconnect Fabrication by Electroless Plating on 3D-Printed Electroplated Patterns
- 15 April 2021
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (16) , 19271-19281
Abstract
The metallic interconnects are essential components of energy devices such as fuel cells and electrolysis cells, batteries, as well as electronics and optoelectronic devices. In recent years, 3D printing processes have offered complementary routes to the conventional photolithography- and vacuum-based processes for interconnect fabrication. Among these methods, the confined electrodeposition (CED) process has enabled a great control over the microstructure of the printed metal, direct printing of high electrical conductivity (close to the bulk values) metals on flexible substrates without a need to sintering, printing alloys with controlled composition, printing functional metals for various applications including magnetic applications, and for in situ scanning electron microscope (SEM) nanomechanical experiments. However, the metal deposition rate (or the overall printing speed) of this process is reasonably slow because of the chemical nature of the process. Here, we propose using the CED process to print a single layer of a metallic trace as the seed layer for the subsequent selected-area electroless plating. By controlling the activation sites through printing by the CED process, we control, where the metal grows by electroless plating, and demonstrate the fabrication of complex thin-film patterns. Our results show that this combined process improves the processing time by more than 2 orders of magnitude compared to the layer-by-layer printing process by CED. Additionally, we obtained Cu and Ni films with an electrical resistivity as low as ∼1.3 and ∼2 times of the bulk Cu and Ni, respectively, without any thermal annealing. Furthermore, our quantitative experiments show that the obtained films exhibit mechanical properties close to the bulk metals with an excellent adhesion to the substrate. We demonstrate potential applications for radio frequency identification (RFID) tags, for complex printed circuit board patterns, and resistive sensors in a Petri dish for potential biological applications.Keywords
Funding Information
- National Science Foundation (CMMI 1727539)
This publication has 48 references indexed in Scilit:
- Three‐Dimensional Printing of Interconnects by Laser Direct‐Write of Silver NanopastesAdvanced Materials, 2010
- Meniscus-Confined Three-Dimensional Electrodeposition for Direct Writing of Wire BondsScience, 2010
- CONTINUOUS STIFFNESS MEASUREMENT DURING INSTRUMENTED INDENTATION TESTINGExperimental Techniques, 2010
- Preparation of Cu@Ag Core–Shell Nanoparticles Using a Two-step Polyol Process under Bubbling of N2 GasChemistry Letters, 2009
- Omnidirectional Printing of Flexible, Stretchable, and Spanning Silver MicroelectrodesScience, 2009
- Direct-Write Patterning Palladium Colloids as a Catalyst for Electroless Metallization for Microwave CompositesLangmuir, 2009
- Large-scale synthesis of copper nanoparticles by chemically controlled reduction for applications of inkjet-printed electronicsNanotechnology, 2008
- Recent Developments in Thin Film Adhesion MeasurementIEEE Transactions on Device and Materials Reliability, 2004
- Three-Dimensional Self-Assembled Monolayer (3D SAM) of n-Alkanethiols on Copper NanoclustersThe Journal of Physical Chemistry B, 2004
- Electroless Copper Deposition Using Glyoxylic Acid as Reducing Agent for Ultralarge Scale Integration MetallizationElectrochemical and Solid-State Letters, 1999