Gas‐assisted injection molded polypropylene: The skin‐core structure
- 24 March 2008
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 48 (5) , 976-986
Abstract
In this article, gas penetration‐induced skin‐core structure of isotactic polypropylene(iPP), which is molded by gas‐assisted injection molding at different gas pressures, was investigated. For comparison, the counterpart was also molded by conventional injection molding (CIM) using the same processing parameters but without gas penetration. They were characterized via PLM, DSC, and SEM. And the crystal morphology at different gas pressures was principally concerned. For the GAIM parts, highly oriented structure is formed in the skin zone, and much less oriented structure in the inner zone (near the gas channel surface). Furthermore, it is suggested that the naked shish structure can be developed in the skin zone of GAIM part, which is molded at higher gas pressures, and shish‐kebab structure is mainly formed in the skin zone of that, which is molded at lower gas pressure. However, for the CIM part, from the skin to the core zone, the dominant morphological feature is spherulite. In a word, the presence of gas penetration notably enhances the oriented structure formation and gives rise to the skin‐core structure. POLYM. ENG. SCI., 2008. © 2008 Society of Plastics EngineersKeywords
This publication has 39 references indexed in Scilit:
- A model of holographic dark energyPhysics Letters B, 2004
- Development of the skin layer in injection moulding: phenomenological modelPolymer, 2004
- The thermomechanical environment and the microstructure of an injection moulded polypropylene copolymerPolymer, 2002
- Instrumented tensile and falling weight impact response of injection-molded ?- and ?-phase polypropylene homopolymers with various melt flow indicesJournal of Applied Polymer Science, 1999
- The influence of molecular weight and mould temperature on the skin-core morphology in injection-moulded polypropylene parts containing weld linesJournal of Materials Science, 1996
- Investigations of the layered structure of injection‐molded polypropylene discs and of its behavior in tensile tests. Dedicated to Prof. H. Janeschitz‐Kriegl on the occasion of his 65th birthdayPolymer Engineering & Science, 1989
- Skin/core morphology and tensile impact strength of injection‐molded polypropyleneJournal of Applied Polymer Science, 1979
- Phase Morphology of High-Impact-Strength Blends of EPDM and Polypropylene. Knit-Line BehaviorRubber Chemistry and Technology, 1977
- Einfluß der Verarbeitungsbedingungen auf die Kristallinität und Gefügestruktur teilkristalliner SpritzgußteileColloid and Polymer Science, 1976
- The skin‐core morphology and structure–property relationships in injection‐molded polypropyleneJournal of Applied Polymer Science, 1972