A program system based on the finite-element method was developed for the detailed behavior analysis of the vicinity of intersection of tubular T-connections. This program system consists of a nonlinear shell analysis program, a. nodal data generation program, and a nonlinear solid analysis program. The strain distributions calculated by this program system show a good agreement with experimental results. Experimental results of fatigue crack initiation life of tubular T-connections are evaluated by applying the calculated equivalent strain amplitude into the fatigue strength curve for the same material as that of the connections and into the X-curve in AWS Code, suggesting unsatisfactory safety factor to the X-curve, especially in the lower cycle range. INTRODUCTION: One of the most basic types 1noffshore structures is a frame structures, in which tubular members are widely used because of their favorable hydrodynamic characteristics. In designing this kind of structures, the analysis of the state of stress and strain in welded tubular connections is one of the most difficult problems. A number of theoretical and experimental studies have been carried out so far 1–5. The method based on the differential equation formerly was predominant in theoretical studies, but it was difficult to obtain accurate solutions in the vicinity of intersection. Studies based on the finite-element method have recently spread. Most of these studies are two-dimensional elastic analysis using flat plate shell elements, while Liaw et al. analyzed elastically tubular K-connections by the three-dimensional isoparametric elements,6 and the authors tried the elastoplastic analysis by the three-dimensional isoparametric elements7. The accuracy of results in these studies, however, is still insufficient for fatigue analysis of tubular connections. It is particularly considered that it i6 impossible to get accurate that stiffness is concentrates in the mid surface of shell. In this paper, a method for the subject mentioned above is proposed. This consists of two kinds of analysis, a shell analysis and a solid analysis, and zooming technique is used for linking these two analyses. BEHAVIOR ANALYSIS BY THE FINITE-ELEMENT METHOD: Outline of Analysis Program: A program flow of the system developed is given in Fig. 1. The nonlinear shell analysis program is an elastoplastic, large deflection flat plate shell analysis program, which was developed as a slight modification of the nonlinear plate structure analysis program made by one of the authors. 8, 9 A triangular flat plate element, which is the main element in this program, is the constant strain element with respect to in-plane deformation and the Zienkiewicz's nonconforming element l0 with respect to out-of-plane deformation. The element is subdivided into layers through the thickness to represent plastification and unloading. An elastic and an elastoplastic large deflection beam element are also included for the purpose of degrees of freedom reduction of framed structures and for the purpose of nonlinear analysis of stiffened plate or shell structures, respectively. The rough flow chart of the nonlinear solid analysis program is given in Fig. 2.