Expansive Grout-Based Gripping Systems for Tensile Testing of Large-Diameter Composite Bars
Authors:
- 1 February 2014
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Materials in Civil Engineering
- Vol. 26 (2) , 250-258
Abstract
Tensile and shear testing to final fracture of large-diameter, fiber-reinforced polymer (FRP) composite round bars is often challenging because local stress triaxiality near the gripping ends can precipitate premature failure at these locations, instead of in the desired test gauge section. A method using expansive grout materials has been used, though its design is impaired by the lack of understanding of the gripping pressure developed by the confined expansive grout material. In this paper, an analytical solution has been derived to correlate the hoop strain on the outer surface of the confining steel pipe (caused by grout expansion in the steel pipe) to the grout’s elastic modulus and coefficient of linear expansion. By experimentally measuring the exterior surface hoop strains of two different steel pipes, the elastic modulus and coefficient of linear expansion were determined. This solution has been generalized to include the composite bar and predict the gripping pressure at the bar-grout interface for any given pipe and composite bar combination. Based on the analytical results, expressions for key design parameters for improved expansive grout-based gripping systems, including the minimum grip length, optimum dimensions of the confinement pipes, and minimum volume of the grout material, have been provided. Based on the improved design, glass FRP bars of diameters 19.0 to 38.0 mm (0.75 to 1.5 in.) were tested without gripping problems and with failure loads up to 534 kN (126 kip), which significantly exceeds 400 kN (90 kip), the load level identified as a threshold of concernKeywords
This publication has 9 references indexed in Scilit:
- Anchor System for Tension Testing of Large Diameter GFRP BarsJournal of Composites for Construction, 2009
- Analysis of stress concentration during tension of round pultruded composite rodsComposite Structures, 2008
- Development and Assessment of a New CFRP Rod–Anchor System for Prestressed ConcreteApplied Composite Materials, 2006
- Design and evaluation of a new bond-type anchorage system for fiber reinforced polymer tendonsCanadian Journal of Civil Engineering, 2004
- Bond Strength and Strain Distribution in the Anchorage Zone of Post-Tensioned CFRP Tendons2000
- A new steel anchorage system for post-tensioning applications using carbon fibre reinforced plastic tendonsCanadian Journal of Civil Engineering, 1998
- Connecting high-performance carbon-fiber-reinforced polymer cables of suspension and cable-stayed bridges through the use of gradient materialsJournal of Computer-Aided Materials Design, 1996
- Expansive cement couplersConstruction and Building Materials, 1995
- The effect of rock mass confinement on the bond strength of fully grouted cable boltsInternational Journal of Rock Mechanics and Mining Sciences, 1992