Predictive Modeling of Porosity Formation in Directionally Solidified AlSi10Mg Alloy: Effects of Temperature Gradient, Solidification Time, and Interface Velocity
- 31 December 2025
- journal article
- Published by International Journal of Automotive Science and Technology in International Journal of Automotive Science And Technology
- Vol. 9 (4) , 455-460
Abstract
Aluminum casting alloys are widely utilized today, particularly in the automotive sector, in line with the pursuit of designing lightweight and energy-efficient vehicles. This widespread application is attributed to their advantageous properties, such as low density, high corrosion resistance, high strength, and superior thermal and electrical conductivity. Porosity, which is one of the most common problems in the products produced by the casting method, renders the product unusable. Since directional solidification is unidirectional heat flow, the effects of solidification parameters, such as temperature gradient, solidification time, solid-liquid interface velocity, on porosity, can be investigated. In this study, the effects of the temperature gradient, solidification time, solid-liquid interface velocity parameters on pore formation were investigated in the one directionally solidified AlSi10Mg alloy at different solidification parameters. Density analysis and microscopic image analysis methods were used according to Archimedes' principle to measure porosity in the samples. When the results obtained are examined one by one, it is seen that the increase in temperature gradient decreases the porosity. However, it has been detected that porosity increases with increasing solid-liquid interface velocity and solidification time. A mathematical model was developed using regression analysis to predict porosity formation with R² = 0.857, showing good correlation between solidification parameters and porosity formation.Keywords
This publication has 27 references indexed in Scilit:
- Enhancing the Microstructure and Mechanical Properties of Cast Aluminum Matrix Composites Through Nano-Al2O3 Reinforcement via CMT and PMC WeldingInternational Journal of Metalcasting, 2024
- Тhe use of aluminium and magnesium alloys in automotive lightweight technologiesJournal of Mechanical Science and Technology, 2023
- Evaluation of the Applicability of Computer-Aided Porosity Testing Methods for Different Pore StructuresMetallography, Microstructure, and Analysis, 2022
- A temperature-dependent atomistic-informed phase-field model to study dendritic growthJournal of Crystal Growth, 2022
- Engineering Lightweight Aluminum and Magnesium Alloys for a Sustainable FutureJournal of the Indian Institute of Science, 2022
- Porosity Characterization of Aluminium Castings by Using Particular Non-destructive TechniquesJournal of Nondestructive Evaluation, 2015
- Effect of cooling rate on the microstructure and solidification characteristics of Al2024 alloy using computer-aided thermal analysis techniqueJournal of Thermal Analysis and Calorimetry, 2014
- Computer-aided cooling curve thermal analysis of near eutectic Al–Si–Cu–Fe alloyJournal of Thermal Analysis and Calorimetry, 2013
- Computer-aided cooling curve thermal analysis used to predict the quality of aluminum alloysJournal of Thermal Analysis and Calorimetry, 2010
- Computer-aided cooling curve analysis of A356 aluminum alloyMetals and Materials International, 2004