Gradient Composite Filtration Material With High Efficiency and Low Resistance for PM 2.5 Protection
Authors:
- 11 November 2025
- journal article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 143 (6)
Abstract
This study develops a gradient composite filtration material for high‐efficiency, low‐resistance PM2.5 protection. The use of a bio‐based gelatin‐carboxymethyl cellulose (CMC) adhesive (6% gelatin+3% CMC) enhanced interlayer bonding while minimizing pore blockage, resulting in a filtration efficiency of 98.6% at a pressure drop of 113.9 Pa. This pressure drop is 20%–30% lower than that achieved with petroleum‐based adhesives, leading to a superior quality factor (QF = 0.037). The gradient structure, which integrates spunbond (S) and meltblown (M) layers, employs synergistic mechanisms—inertial impaction in the outer layer, diffusion capture in the middle layer, and secondary adsorption in the bottom layer—to enhance performance. Experimental results demonstrated exceptional stability under dynamic airflow (10–100 L/min), extreme environmental conditions (temperature: −10°C to 50°C; humidity: 30%–90% RH), and long‐term use (retaining > 95% efficiency over 6 h). The material also showed superior performance and cost‐effectiveness compared to commercial N95 masks, with a material cost of approximately 15 CNY/m 2 . The material also exhibits robust performance under simulated heavy rain, sandstorms, and UV/ozone aging, with filtration efficiency fluctuations below 3.9%. The integration of bio‐adhesive point‐bonding with gradient layering results in a quality factor (QF) 40% higher than that of N95 masks, offering a sustainable alternative for industrial and personal protection.Keywords
Funding Information
- Basic Public Welfare Research Program of Zhejiang Province (LTGS24E080003)
- Science and Technology Program of Zhejiang Province (2025C25052)
- Shaoxing Bureau of Science and Technology (2023A13007)
- Shaoxing Bureau of Science and Technology (2024A13010)
This publication has 25 references indexed in Scilit:
- Experimental investigation and modeling of the flow resistance of compressed nonwoven filter mediaChemical Engineering Research and Design, 2025
- Multi-hierarchical nanofibre membranes composited with ordered structure/nano-spiderwebs for air filtrationJournal of Environmental Chemical Engineering, 2023
- Mechanisms of performance degradation and efficiency improvement of electret filters during neutral particle loadingPowder Technology, 2021
- High‐Performance PM0.3 Air Filters Using Self‐Polarized Electret Nanofiber/NetsAdvanced Functional Materials, 2020
- Influence of sequential punching in layered structure of needle punched nonwoven on the filtration behaviorComposites Part B: Engineering, 2020
- Fabrication of Multifunctional Filters via Online Incorporating Nano‐TiO2 into Spun‐Bonded/Melt‐Blown Nonwovens for Air Filtration and Toluene DegradationMacromolecular Materials and Engineering, 2019
- Electrospinning polyethylene terephthalate/SiO2 nanofiber composite needle felt for enhanced filtration performanceJournal of Applied Polymer Science, 2019
- Air Pollution and Cardiovascular DiseaseJACC, 2018
- Morphology controlled porous poly(lactic acid)/zeolitic imidazolate framework-8 fibrous membranes with superior PM2.5 capture capacityChemical Engineering Journal, 2018
- Application of nanofibers to improve the filtration efficiency of the most penetrating aerosol particles in fibrous filtersChemical Engineering Science, 2006