Maskless 3D Ablation of Precise Microhole Structures in Plastics Using Femtosecond Laser Pulses
- 17 January 2018
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 10 (4) , 4315-4323
Abstract
Femtosecond laser ablation is a robust tool for the fabrication of micro-hole structures. This technique has several advantages compared to other micro-fabrication strategies for reliably preparing micro-hole structures of high quality and low cost. However, few studies have explored the use of femtosecond laser ablation in plastic materials, due to the lack of controllability over the fabrication process in plastics. In particular, the depth profile of micro-hole structures prepared by conventional laser ablation techniques in plastics cannot be precisely and reproducibly controlled. In this paper, a novel, three-dimensional (3D), femtosecond laser ablation technique was developed, for the rapid fabrication of precise micro-hole structures in multiple plastics in air. Using a three-step fabrication scheme, micro-holes demonstrated extremely clean and sharp geometric features. This new technique also enables the precise creation of arbitrary shaped micro-well structures in plastic substrates through a rapid single-step ablation process, without the need for any masks. As a proof-of-concept for practical application, precise micro-hole structures prepared by this novel femtosecond laser ablation technique were exploited for robust resistive-pulse sensing of micro-particles.Keywords
Funding Information
- Australian Research Council (DP160102836)
This publication has 42 references indexed in Scilit:
- Laser‐Directed Assembly of Aligned Carbon Nanotubes in Three Dimensions for Multifunctional Device FabricationAdvanced Materials, 2016
- Solution-Cast High-Aspect-Ratio Polymer Structures from Direct-Write TemplatesACS Applied Materials & Interfaces, 2012
- Molecular fingerprinting with the resolved modes of a femtosecond laser frequency combNature, 2007
- Precision glass machining, drilling and profile cutting by short pulse lasersThin Solid Films, 2005
- Targeted transfection by femtosecond laserNature, 2002
- Hole Taper Characterisation and Control in Laser Percussion DrillingCIRP Annals, 2002
- Three-dimensional hole drilling of silica glass from the rear surface with femtosecond laser pulsesOptics Letters, 2001
- Microelectromechanical systems (MEMS): fabrication, design and applicationsSmart Materials and Structures, 2001
- Ultrashort-pulse laser machining of dielectric materialsJournal of Applied Physics, 1999
- Machining of sub-micron holes using a femtosecond laser at 800 nmOptics Communications, 1995