Microstructures and properties of Mg alloy/DP600 steel dissimilar refill friction stir spot welds
- 1 August 2015
- journal article
- Published by SAGE Publications in Science and Technology of Welding and Joining
- Vol. 20 (6) , 494-501
Abstract
Joining of ZEK100 Mg alloy and Zn coated DP600 steel sheets is studied using refill friction stir spot welding (RFSSW). The RFSSW process involves a tool with independently moving sleeve and pin components, which rotate at a constant speed and penetrate into only the top sheet. Welds could be achieved, which exceeded 4.7 kN shear strength, using the following process parameters: 1800 rev min− 1 tool speed, 3.0 s welding time and 1.5 mm of penetration into the upper ZEK100 sheet. Scanning electron (SEM) and transmission electron microscopy (TEM) are used to characterise the Mg/steel interface. It is revealed that a continuous layer of FeAl2 particles accommodate bonding of the sheets, which appears to have originated from the galvanised coating on the DP600.Keywords
This publication has 15 references indexed in Scilit:
- Comparison of microstructure and mechanical properties of conventional and refilled friction stir spot welds in AA 6061-T6 using filler plateTransactions of Nonferrous Metals Society of China, 2013
- Microstructure and failure mechanisms of refill friction stir spot welded 7075-T6 aluminum alloy jointsMaterials & Design (1980-2015), 2013
- On the feasibility of friction spot joining in magnesium/fiber-reinforced polymer composite hybrid structuresMaterials Science and Engineering: A, 2011
- Mechanical and microstructural investigation of friction spot welded AA6181-T4 aluminium alloyMaterials & Design (1980-2015), 2011
- FSSW of Mg to Al with a Cold Sprayed Interlayer2011
- Characterisation of interface of steel/magnesium FSWScience and Technology of Welding and Joining, 2011
- Preliminary Investigation of the Microstructure and Mechanical Behaviour of 2024 Aluminium Alloy Friction Spot WeldsMATERIALS TRANSACTIONS, 2011
- Redetermination of iron dialuminide, FeAl2Acta Crystallographica Section C Crystal Structure Communications, 2010
- Joint formation in dissimilar Al alloy/steel and Mg alloy/steel friction stir spot weldsScience and Technology of Welding and Joining, 2009
- The Influence of Weld Microstructure on Mechanical Properties of Alclad AA2024-T3 Friction Spot WeldedSAE International Journal of Advances and Current Practices in Mobility, 2008