A High-Performance Dual-Cantilever High-Shock Accelerometer Single-Sided Micromachined in (111) Silicon Wafers
Authors:
- 7 October 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 19 (6) , 1515-1520
Abstract
A single-side processed dual-cantilever high-shock accelerometer in (111) silicon wafers is proposed in this paper. The device is formed by using advanced silicon surface and bulk micromachining technologies, including deep-reactive ionic etch and lateral under-etching structural release. Because the sensor is fabricated in (111) silicon wafer and has a single-chip single-side structure, it facilitates simple post-packaging, reduced device dimension, and low cost mass production. The controllable gap distance between the bottom surface of the cantilever and the substrate can be used for restraining cross-sensitivity of orthogonal direction. The performance of the accelerometer is examined by using a free dropping hammer system. The results of the shock test show the acceleration sensitivity of 0.71 μVg-1 for a 20 500 g shock acceleration under 3.3 V power supply and the resonant frequency of 79 kHz. The zero-point offset temperature drift of the sensor is 89 within the temperature range of to 120 .Keywords
This publication has 9 references indexed in Scilit:
- A silicon micromachined high-shock accelerometer with a bonded hinge structureJournal of Micromechanics and Microengineering, 2007
- Selective silicon-on-insulator (SOI) implant: a new micromachining method without footing and residual stressJournal of Micromechanics and Microengineering, 2005
- A high-performance micromachined piezoresistive accelerometer with axially stressed tiny beamsJournal of Micromechanics and Microengineering, 2005
- Simulation, fabrication and testing of bulk micromachined 6H-SiC high-g piezoresistive accelerometersSensors and Actuators A: Physical, 2003
- Silicon micromachined high-shock accelerometers with a curved-surface-application structure for over-range stop protection and free-mode-resonance depressionJournal of Micromechanics and Microengineering, 2002
- Surface/bulk micromachined single-crystalline-silicon micro-gyroscopeJournal of Microelectromechanical Systems, 2000
- Mesa-supported, Single-crystal Microstructures Fabricated by the Surface/Bulk Micromachining ProcessJapanese Journal of Applied Physics, 1999
- Dynamic high-g loading of MEMS sensors: ground and flight testing1998
- Comb-drive actuators for large displacementsJournal of Micromechanics and Microengineering, 1996