Comparison of structure development in injection molding of isotactic and syndiotactic polypropylenes
Authors:
- 1 August 2002
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 42 (8) , 1642-1656
Abstract
A comparative study of the crystallization and orientation development in injection molding isotactic and syndiotactic polypropylenes was made. The injection molded samples were characterized using wide angle X‐ray diffraction (WAXD) techniques and birefringence. The injection molded isotactic polypropylene samples formed well‐defined sublayers (skin, shear and core zones) and exhibited polymorphic crystal structures of the monoclinic α‐form and the hexagonal β‐form. Considerable amounts of β‐form crystal were formed in the shear and core zones, depending on the injection pressure or on the packing pressure. The isotactic polypropylene samples had relatively high frozen‐in orientations in the skin layer and the shear zone. The injection molded syndiotactic polypropylene exhibited the disordered Form I structure, but it did not appear to crystallize during the mold‐filling stage because of its slow crystallization rate and to develop a distinct shear zone. The core zone orientation was greatly increased by application of high packing pressure. The isotactic polypropylene samples exhibited much higher birefringence than the syndiotactic polypropylene samples at the skin and shear layers, whereas both materials exhibited similar levels of crystalline orientation in these layers.Keywords
This publication has 26 references indexed in Scilit:
- Molecular Orientation Behaviors with Optical Measurement and X-Ray Diffraction for Strip-Biaxially Stretched Syndiotactic Polypropylene Films.KOBUNSHI RONBUNSHU, 1999
- Wide-Angle X-Ray, Densitometric and Microscopical Studies on Injection Molded Polypropylene DisksInternational Polymer Processing, 1997
- Injection molding of semicrystalline polymers. II. Modeling and experimentsJournal of Applied Polymer Science, 1995
- Structure of a new crystalline phase of syndiotactic polypropyleneJournal of Polymer Science Part B: Polymer Physics, 1991
- Small- and wide-angle X-ray scattering investigations of injection-moulded polypropyleneJournal of Applied Crystallography, 1991
- Optical and Mechanical Measurements to Characterize Injection Molded Polypropylene PlatesInternational Polymer Processing, 1989
- Structure of skin layer in injection‐molded polypropyleneJournal of Applied Polymer Science, 1988
- Einfluß der Verarbeitungsbedingungen auf die Kristallinität und Gefügestruktur teilkristalliner SpritzgußteileColloid and Polymer Science, 1976
- Molecular orientation in injection moldingJournal of Applied Polymer Science, 1974
- The skin‐core morphology and structure–property relationships in injection‐molded polypropyleneJournal of Applied Polymer Science, 1972