Optimization of permeate flux produced by solar energy driven membrane distillation process using central composite design approach
Authors:
- 13 April 2016
- journal article
- Published by IWA Publishing in Water Science & Technology
- Vol. 74 (1) , 87-98
Abstract
Membrane distillation (MD) is considered as a relatively high-energy requirement. To overcome this drawback, it is recommended to couple MD process with solar energy as renewable energy source in order to provide heat energy required to optimize its performance to produce permeate flux. In the present work, an original solar energy driven direct contact membrane distillation pilot plant was built and tested under actual weather conditions at Jeddah, KSA, in order to model and optimize permeate flux. The dependency of permeate flux to various operating parameters such as feed temperature (46.6–63.4 °C), permeate temperature (6.6–23.4 °C), feed flow rate (199–451 L/h) and permeate flow rate (199–451 L/h) were studied by response surface methodology based on central composite design approach. The analysis of variance (ANOVA) confirmed that all independent variables had significant influence on the model (where P-value R2 = 0.9644 and R2adj = 0.9261) obtained by ANOVA demonstrated good correlation between experimental and predicted values of the response. The optimized conditions, determined using desirability function, were Tf = 63.4 °C, Tp = 6.6 °C, Qf = 451 L/h and Qp = 451 L/h. Under these conditions, the maximum permeate flux of 6.122 kg/m2.h was achieved, which was close to the predicted value of 6.398 kg/m2.h.Keywords
This publication has 21 references indexed in Scilit:
- Performance improvement of PVDF hollow fiber-based membrane distillation processJournal of Membrane Science, 2011
- Removal of arsenic from contaminated groundwater by solar-driven membrane distillation using three different commercial membranesWater Research, 2010
- Response surface modeling and optimization of composite nanofiltration modified membranesJournal of Membrane Science, 2010
- Guidelines for preparation of higher flux hydrophobic/hydrophilic composite membranes for membrane distillationJournal of Membrane Science, 2009
- Potential of membrane distillation in seawater desalination: Thermal efficiency, sensitivity study and cost estimationJournal of Membrane Science, 2008
- Response surface methodology (RSM) as a tool for optimization in analytical chemistryTalanta, 2008
- Optimization of extraction process of crude polysaccharides from wild edible BaChu mushroom by response surface methodologyCarbohydrate Polymers, 2008
- Application of Response Surface Methodology and Experimental Design in Direct Contact Membrane DistillationIndustrial & Engineering Chemistry Research, 2007
- Application of response surface methodology for the biosorption of copper using Rhizopus arrhizusJournal of Hazardous Materials, 2007
- Effect of pore size distribution and air flux on mass transport in direct contact membrane distillationJournal of Membrane Science, 2003