Mechanical characterization of nacre as an ideal-model for innovative new endoprosthesis materials
- 25 May 2010
- journal article
- research article
- Published by Springer Nature in Archives of orthopaedic and trauma surgery
- Vol. 131 (2) , 191-196
Abstract
Introduction To mimic the impressive mechanical behavior of natural ceramics for technical or biomedical applications, interest has been focused on nacre, a natural composite consisting of imbricated aragonite platelets embedded in a protein matrix. Nacre is an ideal model material for implants, since it possesses favorable strength and toughness properties compared to the component materials of which it is composed. The focus of the present study was to test standardized parameters which are good indicators of the material’s suitability as an implant material. Materials and methods A three-point bending test was performed on polished nacre samples according to international standards for Young’s modulus, bending strength and fracture toughness. A total of 60 nacre samples were tested, with 5 samples each in 4 states of hydration (dry, distilled water, 0.9% NaCl and sea water). As a basis for comparison, 10 samples of a newly developed bioceramic material were tested for fracture toughness. Results The fracture toughness of nacre tended to be higher for specimens conditioned in 0.9% NaCl than for dry specimens (5.3 ± 0.6 vs. 4.3 ± 0.7 MPam1/2, p = 0.061). The fracture toughness of the bioceramic investigated was observed to be somewhat higher than nacre (5.8 ± 0.4 vs. 4.3 ± 0.7 MPam1/2, p ≤ 0.001). Discussion and conclusion The increase in fracture toughness of hydrated nacre was not as large as would be expected based on the difference in stiffness of the matrix material after hydration that has been reported. Modulus and toughness were similar to published values and the fracture toughness observed was somewhat higher than reported for alumina implant ceramics, which are in use in total hip arthroplasty. In a direct comparison, we found that a newly developed alumina bioceramic material can in fact match nature in terms of fracture toughness.Keywords
This publication has 10 references indexed in Scilit:
- Tough, Bio-Inspired Hybrid MaterialsScience, 2008
- Influence of preparation of ceramic SEVNB specimens on fracture toughness testing resultsDental Materials, 2008
- Biomimetics for next generation materialsPhilosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2007
- Rigid Biological Systems as Models for Synthetic CompositesScience, 2005
- Materials become insensitive to flaws at nanoscale: Lessons from natureProceedings of the National Academy of Sciences, 2003
- Mechanical properties of nacre and highly mineralized boneProceedings Of The Royal Society B-Biological Sciences, 2001
- Comparison of three fracture toughness testing techniques using a dental glass and a dental ceramicDental Materials, 1998
- Comparison of nacre with other ceramic compositesJournal of Materials Science, 1990
- The mechanical design of nacreProceedings of the Royal Society of London. B. Biological Sciences, 1988
- Mechanical properties of mother of pearl in tensionProceedings of the Royal Society of London. B. Biological Sciences, 1977