A cumulative standard deviation sum based method for high resistance fault identification and classification in power transmission lines
Open Access
- 26 September 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Protection and Control of Modern Power Systems
- Vol. 3 (1) , 30
Abstract
High resistance fault poses an enormous challenge to the existing algorithms of fault detection and fault classification. In this paper, the standard deviation and accumulation method are employed to perform the fault detection and classification. It is primarily built in two stages. Firstly, the standard deviations for the measured current’s signals of the local and remote terminals is computed to extract the fault feature. Secondly, the cumulative approach is used to enlarge the fault feature to perform the high resistance fault. The proposed scheme is known as Standard Deviation Index (SDI), and it is obtained for the three phases and zero sequence. The proposed algorithm has been tested through different fault circumstances such as multiple faults locations, fault resistances, and fault inception time. Moreover, far-end faults with high-resistance, faults happened nearby the terminal, faults considering variable loading angle, sudden load change, different sampling frequency, bad signaling and a fault occurred in the presence of series compensation are also discussed. The results show that the proposed scheme performed remarkably well regarding the fault with resistance up to 1.5kΩ and can be detected within a millisecond after the fault inception. Additionally, the computational simplicity that characterizes the processes makes it more efficient and suitable for domain applications.Keywords
Funding Information
- National Natural Science Foundation of China (51777173, 51525702)
This publication has 30 references indexed in Scilit:
- Critical aspects on wavelet transforms based fault identification procedures in HV transmission lineIET Generation, Transmission & Distribution, 2016
- Fault identification in electrical power distribution system using combined discrete wavelet transform and fuzzy logicJournal of Electrical Systems and Information Technology, 2015
- Enhancing the performance of transmission line directional relaying, fault classification and fault location schemes using fuzzy inference systemIET Generation, Transmission & Distribution, 2015
- A rough membership neural network approach for fault classification in transmission linesInternational Journal of Electrical Power & Energy Systems, 2014
- Design and implementation of a wavelet analysis‐based shunt fault detection and identification module for transmission lines applicationIET Generation, Transmission & Distribution, 2014
- Accurate Fault Classifier and Locator for EHV Transmission Lines Based on Artificial Neural NetworksMathematical Problems in Engineering, 2014
- An ANFIS-based fault classification approach in power distribution systemInternational Journal of Electrical Power & Energy Systems, 2013
- A systematic fuzzy rule based approach for fault classification in transmission linesApplied Soft Computing, 2013
- Fault phase selection scheme of EHV/UHV transmission line protection for high-resistance faultsIET Generation, Transmission & Distribution, 2012
- A Moving Sum Approach for Fault Detection of Power SystemsElectric Power Components and Systems, 2006